Use and Care Manual

-29-
W1812 Owner's Manual (Mfd. Since 02/11)
OPERATIONS
Figure 43. Correct support for tall
workpieces.
Edge Moulding Tall Workpieces
When cutting edge profiles on workpieces that are taller
than they are wide, you must clamp wooden extension
rails to the table so they support at least 75% of the
workpiece height on both sides (see Figure 43).
Never attempt to use the low profile metal guide rails
that came with this machine if they do not adequately
support tall workpieces. If the workpiece slips out of the
rails because they are too low, the workpiece can be
ejected from the machine, causing severe injury.
CORRECT
INCORRECT