Use and Care Manual

-4-
W1812 Owner's Manual (Mfd. Since 02/11)
INTRODUCTION
Main Specifications
Cutting Capacities
Maximum Planing Width ............................................................................................ 7 in.
Maximum Planing Depth ..........................................................................................
1
⁄8 in.
Maximum Planing Height ........................................................................................ 7
1
⁄2 in.
Maximum Profile Width ......................................................................................... 6
3
⁄4 in.
Maximum Profile Depth ...........................................................................................
3
⁄4 in.
Minimum Stock Thickness .........................................................................................
1
⁄4 in.
Minimum Stock Length ............................................................................................. 9 in.
Knife Information
Number of Knives ....................................................................................................... 2
Knife Type ............................................................................................................. HSS
Knife Length ...................................................................................................... 7
1
⁄8 in.
Knife Width ........................................................................................................ 1
1
⁄2 in.
Knife Thickness .....................................................................................................
1
⁄4 in.
Number of Cuts Per Minute ......................................................................................14,000
Number of Cuts Per Inch .........................................................................................64-300
Cutterhead Information
Cutterhead Type .................................................................................................. Square
Cutterhead Diameter ............................................................................................ 1
1
⁄4 in.
Cutterhead Speed ............................................................................................. 7000 RPM
Table Information
Table Length w/Wings ..........................................................................................36
1
⁄4 in.
Table Length w/o Wings........................................................................................14
1
⁄8 in.
Table Width .........................................................................................................10 in.
Table Thickness ....................................................................................................
7
⁄16 in.
Extension Wing Length ............................................................................................11 in.
Extension Wing Width .......................................................................................... 8
9
⁄16 in.
Floor to Table Height ...........................................................................................30
3
⁄8 in.
Other Information
Number of Dust Ports ................................................................................................... 1
Dust Port Size ........................................................................................................ 4 in.
Measurement Scale Units ........................................................................................ Inches
Construction Materials
Cabinet ........................................................................................................... Formed Steel
Body Assembly .........................................................................................................Cast Iron
Cutterhead Assembly ......................................................................................................Steel
Table & Extension Wing ........................................................................ Precision Ground Cast Iron
Paint ............................................................................................................... Powder Coat
Infeed and Outfeed Rollers ...........................................................................Rubber Coated Steel
Other
Country of Origin ....................................................................................................... Taiwan
Warranty .................................................................................................................. 2 Year
Approximate Assembly Time ......................................................................................45 Minutes
Serial Number Location .................................................................................... Machine ID Label
Certified by a Nationally Recognized Testing Laboratory (NRTL) ....................................................Ye s
Features
Heavy-Duty Cast Iron Handwheel with Inch Measurement Scale for Cutterhead Housing Lift
Precision-Ground Cast Iron Infeed and Outfeed Extension Wings
Dovetailed Way for Cutterhead Housing with Precision Gib Adjustments
Pedestal-Mounted Control Switch with Variable Speed Control
Model W1812 Machine Specifications, Page 2 of 2