Full Product Manual

-25-
Model W1831 (For Machines Mfd. Since 6/15)
SERVICE
22. Install spindle washer (#51) and retaining ring (#50),
as shown in Figure 26.
27. Re-install housing base (#76) onto cast iron table
(#7) shown in Figure 29. Ensure that brown wiring
(#72) is connected to the rectifier (#69), then
re-install bottom plate (#90).
Figure 26. Spindle washer and retaining
ring installed.
23. Install compression spring (#49), ensuring hooked
end is locked into driver gear (#54) shoulder, as
shown in Figure 27.
24. Install bearing sleeve (#48) into compression spring
(#49).
25. Install bearing cover (#42).
Compression
Spring
Hooked End
Figure 27. Hooked end of compression
spring locked into driver gear shoulder.
Retaining
Ring
Spindle
Washer
26. Install gear support (#66), as shown in Figure 28.
Figure 28. Installing gear support.
Gear Support
Figure 29. Base and bottom re-installed.
Bottom
Plate
Cast Iron
Table
Housing
Base