Use and Care Manual

-13-
Model W1844 (For Machines Mfd. Since 5/17)
SETUP
Unpacking
This machine has been carefully packaged for safe
transportation. If you notice the machine has been
damaged during shipping, please contact your authorized
Shop Fox dealer immediately.
Inventory
The following is a list of items shipped with your machine.
Before beginning setup, lay these items out and inventory
them.
Note:
If you cannot find an item on this list, carefully
check around/inside the machine and packaging materials.
Often, these items get lost in packaging materials while
unpacking or they are pre-installed at the factory.
Box 1 Contents (Figure 5) Qty
A. Wall Bracket ................................................1
B. Filter Cleaning Handle ....................................1
C. Motor Mounting Plate .....................................1
D. Open-End Wrench 10 x 12mm ...........................1
E. Bag Clamp ..................................................1
F. Impeller Housing & Fan/Motor Assembly ..............1
Box 2 Contents (Figure 6) Qty
G. Canister Filter ................................ ..............1
H. Foam Strip 2 x 16 x 1250mm ............................1
Hardware and Bags (Not Shown)
• Flange Bolts
1
⁄4-20 x
1
⁄2" .................................4
• Flange Bolts
1
⁄4-20 x
3
⁄4" .................................6
• Dust Collection Bag .......................................1
G
Figure 6. Box 2 contents.
C
D
E
B
A
F
Figure 5. Box 1 contents.
H