Use and Care Manual

-19-
Model W1844 (For Machines Mfd. Since 5/17)
SETUP
Figure 16. Removing switch key from
paddle switch.
Test Run
Serious injury or death can result
from using this machine BEFORE
understanding its controls and related
safety information. DO NOT operate, or
allow others to operate, machine until
the information is understood.
DO NOT start machine until all
preceding setup instructions have been
performed. Operating an improperly set
up machine may result in malfunction
or unexpected results that can lead
to serious injury, death, or machine/
property damage.
Once assembly is complete, test run the machine to
ensure it is properly connected to power and safety
components are functioning properly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from power,
and fix the problem BEFORE operating the machine again.
The
Troubleshooting table in the SERVICE
section of this
manual can help.
To test run machine, do these steps:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON, verify motor operation, then turn
machine OFF.
The motor should run smoothly and without unusual
noises or vibration.
4. Remove switch disabling key (see example).
5. Try to start machine with paddle switch. The
machine should not start.
— If machine does not start, the switch disabling
feature is working as designed.
— If machine does start, immediately stop the
machine. The switch disabling feature is not
working correctly. This safety feature must
work properly before proceeding with regular
operations. Call Tech Support for help.
The test run consists of verifying the following: 1) The
motor powers up and runs correctly, and 2) the safety dis-
abling mechanism on the switch works correctly.