Operation Manual

Care & Maintenance
Wheels and Tyres (GK10only)
The wheels of your Shoprider® scooter have split rims. This allows any
punctures to be repaired easily. To change the wheels remove the center 13 mm
bolt and slide the wheel off its axle. Take care not to lose the drive key on the
rear wheels. When changing a tyre you must deflate the tyre first. Remove the
four bolts to split the rim if required. Ensure that when refitting the wheel the
retaining bolt is fitted with a locking washer (with drive key for the rear wheel).
Tyre pressure is recommended to be kept at 30 psi on the rear tyres and 25 psi
on the front. Note when refitting the tube a small amount of air in the tube will
prevent the tube from pinching when reassembling the split rim.
CAUTION: On the tyre it states maximum tyre pressure is 50psi. This is a
maximum tyre pressure and the tyres should never be inflated to this
pressure.
ATTENTION: Tyres should be maintained at the correct pressure noted
above to ensure even wear and ride comfort.
Wheels and Tyres (QT3, QT4 & GK9)
These scooter have polyurethane tyres fitted and they require no regular
maintenance
Cleaning
Your Shoprider® scooter can be cleaned as required however as with all
electrical equipment you must ensure that extreme care is used to not water
damage any sensitive parts.
Please read the following warnings:
Only use a soft damp cloth.
NEVER use a hose to wash your scooter.
DO NOT use abrasive cleaning products ± Mild detergent only should be used.
General Scooter Maintenance
Every six months check the tiller base bolts, wheel axle bolts, and arm rest angle
adjustment bolts and tighten as necessary.
Also check the seat and arm rest tightening knobs and tighten as needed. If your
scooter is fitted with authorised Shoprider® accessories please check these to
ensure the tightening knobs and bolts are secure.
Lubrication
Approximately every six months you should lubricate the following parts on
your Shoprider®.
The lubrication points are as follows:
Seat post only.
The suggested lubricants should be done with light grade of grease.
Please note: The breather hole on top of the Transaxle is NOT a grease nipple.
PLEASE NOTE ANY OTHER LUBRICATION MUST BE COMPLETED
BY AN AUTHORSED SHOPRIDER® DEALER