Start 8 ™ Model # GK9 Portable Scooter User Manual 7/8/2009SE 1
Table of Contents INTRODUCTION…………………………………………………………….…………33 FEATURE GUIDE…………………………………………………………….………..33 SAFETY ADVICE………………………………………………………………….…...44 EMI WARNING………………………………………………………….…………….. 5-6 ADJUSTMENTS………………………………………………….……………………..7 7-8 SCOOTER TILLER CONTROLS………………………………….…………………..1 9 DRIVE/FREEWHEEL OPERATION…………………………………………………10 10 STARTING TO DRIVE YOUR SCOOTER………………………………………….11 11 EXTRA GUIDELINES IN THE CONTROL OF YOUR SCOOTER……………….12 12 TRANSPORT/STORAGE……………………………………………………………..
INTRODUCTION Congratulations on your purchase of the Shoprider® Start 8 8 Portable scooter. The Start 8 is the ultimate combination of style, comfort and portability. The Start 8 includes several innovative and convenient features. The Start 8 goes with you wherever you go and can be assembled or disassembled in just seconds with wireless quick-connect components. The Start 8 is light and compact, and can be stored in small areas such as the trunk or back seat of your car.
SAFETY ADVICE • • • • • • • • • • • • • • • • • • • • • • • • • • • DO NOT carry passengers. DO NOT exceed inclines over 6 degrees (10% grade). DO NOT turn on steep inclines. DO NOT turn suddenly at high speeds. DO NOT get on or off the scooter unless the brake is on and the scooter is switched off. DO NOT switch off the scooter while the scooter is moving. DO NOT drive the scooter where you can not safely or legally walk. DO NOT drive the scooter on the road, street or highway.
EMI WARNING Shoprider® scooters may be susceptible to electromagnetic interference (EMI), which is a kind of interfering electromagnetic energy (EM) emitted from sources such as radio stations, TV stations, amateur radio (HAM) transmitters, two-way radio, and cellular phones. The interference (from radio wave sources) can cause the scooter to release its brakes, move by itself, or move in unintended directions. It can also permanently damage the scooter’s control system.
WARNINGS 1. Do not operate hand-held transceivers (transmitters-receivers), such as citizens band (CB) radios, or turn ON personal communication devices, such as cellular phones, while the scooter is turned ON. 2. Be aware of nearby transmitters, such as radio or TV stations, and try to avoid coming close to them. 3. If unintended movement or brake release occurs, turn the scooter OFF as soon as it is safe. 4.
ADJUSTMENTS Tiller Angle Adjustment (Fig 2) At the base of the tiller is a round knob. Turn the knob counterclockwise to loosen the tiller and select the desired tiller angle. Turn the knob clockwise to securely lock the tiller into place. NOTE: For Safety, this lock is designed to break away if the scooter is driven when locked. Tiller Angle Adjustment Figure 2 Folding the Tiller (Fig 3) Fold down the tiller by loosening the tiller angle adjustment knob located at the base of the tiller (fig 2).
Seat Height Adjustment (Fig 5) Remove seat as described (fig 4). Remove battery pack (refer to disassembly section). Using two 13mm wrenches, remove locking bolt and nut. Adjust seat post up or down to desired position. The seat height can be adjusted to five different positions by inserting the locking bolt in the desired hole. Replace washer and nut and tighten. Replace battery pack and seat.
SCOOTER TILLER CONTROLS (FIG 7) Speed Controls The speed control allows you to set a speed between slow (turtle) and fast (rabbit). Battery Level Indicator Gauge Where the needle sits, shows the amount of charge left in your batteries. The amount of charge will only show at its true level when the scooter is in drive. Always charge the batteries completely before beginning out on any journey.
DRIVE/FREEWHEEL OPERATION (FIG 8) The drive/freewheel lever (yellow ball handle) is located under the seat at the right rear of unit. This lever allows you to disengage the drive mechanism and push the scooter while in freewheel mode. To disengage the drive mechanism (neutral), move the lever forward (the scooter can now be pushed). To re-engage the drive mechanism (drive), move the lever backward (now the unit may be driven).
STARTING TO DRIVE YOUR SCOOTER First Time Use Prior to using your Start 8 Portable scooter for the first time, you must charge the batteries fully (refer to Battery Charging Procedures). Charging may take up to 12 hours. Charging the batteries completely prior to first time use will benefit battery efficiency. Failure to do so may cause permanent damage. Getting Start 8ed • Select a level area with plenty of space.
EXTRA GUIDELINES IN THE CONTROL OF YOUR SCOOTER Ramps The stability of your scooter is governed by several factors such as the seating position, the angle of the slope and your height and weight. When approaching an incline, do so directly and not at an angle and where ever possible avoid making turns. When going down a ramp or slope keep the speed settings to slow. This will ensure there is a safe controlled descent. When the thumb levers are released the scooter will slowly stop.
TRANSPORT / STORAGE The Start 8 Portable scooter is designed to be quickly and easily disassembled into sections for transportation and storage. Follow these simple guidelines for disassembly: 4 Start 8 8 Disassembly (Fig 10 & 11) 2 1) Remove the front basket: Lift basket up and off. 2) Fold the seat down and remove: Pull 1 yellow swivel seat lever up and lift seat up and off. 3) Remove battery pack: Turn yellow 5 3 battery pack locking lever to unlock position.
BATTERIES AND BATTERY CHARGING The Shoprider® Start 8 Portable scooter is supplied with maintenance-free, sealed lead acid batteries. For easy handling, the batteries are contained within a battery pack. Battery life and performance may be affected by temperature, terrain, condition of battery, the weight of the user, care of batteries, and other conditions. The battery needle gauge is only a guide and is most effective when the scooter is moving, only then is the true discharge level displayed.
MAINTENANCE Tires Since your tires are flat free tires, there is no need to ever worry about tire air pressure. General Maintenance and Lubrication • Inspection for loose wheel bolts, seat and arm tightening bolts, and other nuts and bolts is recommended on a regular basis. • Most lubricated components on the Start 8 Portable scooter are designed to be maintenance free and are sealed. Therefore lubrication is not required for these components.
TECHNICAL SPECIFICATIONS UNIT SPECIFICATIONS Overall Dimensions: L1 x W x H Number, Size of Tires Suggested User Weight (on the Level Road) Weight of Rear Chassis w/ Drive Train Assy Total Weight (w/ 12Ah Battery Pack, Basket, Seat) Weight of Seat w/ Arm Assys Battery Pack Module Weight Battery Module Capacity Charger Output Power of Motor Maximum Speed2 Maximum Climbing Angle (based on user weight of 100kg/220lb) / Safe Climbing Angle inches Start 8 GK9 (SE) 41.
QUARTERLY INSPECTION For your own safety, quarterly inspection and service on the product has to be performed and signed by an authorized provider. Maintenance records (below) should be kept at all times. The manufacturer / distributor / vendor will be indemnified from any product liability claim if the above maintenance / service requirement is not met. NOTE! Regular (Monthly) inspection is strongly recommended by the manufacturer to ensure ultimate performance of the vehicle.
NOTES: 7/8/2009SE 18
WARRANTY Please refer to warranty information included with unit. DISCLAIMER Congratulations on your purchase of the Shoprider® Start 8 Portable scooter. It is not intended to be used by individuals with physical limitations that could prevent the user from operating this unit safely. Shoprider® disclaims all responsibility for any personal injury or property damage, which may occur as a result of improper or unsafe use of its products.