INSTALLATION MANUAL HOLD FOR DELCO APPROVAL - NEW LOGO Form No. 128-4487A Rev. A - Replaced old Delco Logo with New. 2-1-95.
PACKING LIST MAIN UNIT Changer FM Modulator Commander INSTALLATION PARTS Bracket (L) Bracket (R) Hexagonal bolt with washer (M5 x 8) x1 x1 x4 Tapping screw (M5 x 12) Tapping screw (M3 x 12) Din 8 pin cable Seal x4 x2 5mx1 x1 OTHER ACCESSORIES 2 CD Magazine Index seal sheet Installation Manual Owner's guide x1 x1 x1 x1
BEFORE INSTALLING THE UNIT Transport Lock Screws The mechanism in the CD changer is "locked" into place during shipment by the transport screws. Be sure to remove the screws prior to installation. Caution After removing the transport lock screws, place the supplied seals over the screw holes. These seals are used to keep dust out of the unit, which could cause a malfunction.
INSTALLATION (1) The unit can be installed vertically or horizontally. The position of the built-in anti-vibration springs (left and right side), must correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration compensation will not be effective. Horizontal Installation Note The unit is shipped with the springs installed for horizontal installation. Vertical Installation It is necessary to change the spring attachment position.
INSTALLATION (2) Procedure for Vertical Installation Note If the anti-vibration spring position has been changed and verified for vertical mounting (as shown on page 3), start with step 2. 1 It is necessary to change the spring attachment position. 1) Remove the lock screws on the side of the set using a Phillips screwdriver. 2) Turn the spring attachment to the (V) mark side using a screwdriver. 3) Replace the removed screws on the (V) mark side.
WIRING To car antenna FM Modulator Fuse 2A RF output (89.1MHz or 88.7MHz) Fuse 5A Antenna socket +12 volt Accessory/Switched (ORANGE/WHITE STRIPE) Connect this wire to a point which is energized when the ignition switch is turned to the "ON" or "ACCESSORY" position. +12 volt Constant (GREEN/WHITE STRIPE) Connect this lead to the cable to which power is continuously supplied and which has been passed through the vehicle's fuse block. Ground (BLACK) Screw this to a metal part of the vehicle.
INSERT VEHICLE WIRING DIAGRAM DWG. NO.
Features: Shuffle Play Conveniently shuffles the tracks on the disc selected, or entire 10 discs giving the user a different concert mix every time. Disc Select Easily moves up (+) or down (-) discs with the disc select buttons. Track Search Advances to the next track on the disc or returns to the beginning of the current track. Track/Disc Repeat Repeat current track or disc. Allows user to play favorite CD or songs over.
