User`s manual

RGBW 16-Bit Mode 35
SL NITRO 510C LED STROBE Luminaire
Installation & User’s Manual
Sh wline
Figure 18: Linear & Checker Pattern
7 Control Channel 0 - 255 0 - 100% 0
Control channel operation. Set control channel
value to desired action, hold value for at least 5
seconds, then turn to 0. Set control channel
value to 0 without any scaling.
Default Setting on Console = DMX 0-4
Dimming Curve_linear = DMX 30 - 34
Dimming Curve_Square = DMX 35- 39
Dimming Curve_S-Curve = DMX 40 - 44
Dimming Curve_PL-Curve = DMX 45 - 49
Calibration_OFF = DMX 70 - 74
Calibration_ON = DMX 75 - 79
Fan_Auto = DMX 80 - 84
Fan_Off = DMX 85 - 89
The following is only available for "Zones
Mapping" protocol. The following is instantly
applied and DOES NOT require the 5 second
hold.
Combined zone control - (all zones follow zone 1
setting) = DMX 100 - 104
The following is only available for "2 Zones
Modes". The following is instantly applied and
does not require the 5 second hold:
Linear Pattern = DMX 105 - 108*
Checker Pattern = 109 - 112*
*See
Figure 18.
Not Used = DMX 113 - 250 (Reserved for future
use)
8 Zone 1 - 6 Intensity 0 - 255 0 - 100% 0
8-bit control for the intensity of the Zones - 0 to
255 (full)
9 Red 1 - 6 - High
0 - 65535 0 - 100% 0 16-bit control of Red LEDs from 0 to full
10 Red 1 - 6 - Low
11 Green 1 - 6 - High
0 - 65535 0 - 100% 0 16-bit control of Green LEDs from 0 to full
12 Green 1 - 6 - Low
13 Blue 1 - 6 - High
0 - 65535 0 - 100% 0 16-bit control of Blue LEDs from 0 to full
14 Blue 1 - 6 - Low
15 White 1 - 6 - High
0 - 65535 0 - 100% 0 16-bit control of White LEDs from 0 to full
16 White 1 - 6 - Low
17
Zone 1 - 6
Strobe Duration
0 - 255 0 - 100% 0
Controls strobe duration. Refer to "Strobe
Duration DMX Timing Detail" on page 47.
18
Zone 1 - 6
Strobe Rate
0 - 255 0 - 100% 0
Controls strobe rate operation. Refer to "Strobe
Rate DMX Timing Detail" on page 46.
Table 15: DMX Channel Mapping (RGBW 16-Bit Mode)
Zone 1 Zone 2 Zone 3
Zone 4 Zone 5 Zone 6
Top of Luminaire
Bottom of Luminaire
Front of Luminaire
Note, this is a graphical representation
Linear Pattern
Zone 1 Zone 2 Zone 3
Zone 4 Zone 5 Zone 6
Top of Luminaire
Bottom of Luminaire
Front of Luminaire
Checker Pattern
for reference purposes only.