User manual

6
Maintenance
The Showtec DJ Switch requires almost no maintenance. However, you should keep the unit clean.
Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in
liquid. Keep connections clean. Disconnect electric power, and then wipe the audio connections with a
damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric
power.
Replacing a Fuse
Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the
fuse burns out, the product will not function whatsoever. If this happens, follow the directions below to do
so.
1. Unplug the unit from electric power source.
2. Insert a screwdriver into the slot in the fuse cover. Turn the screwdriver to the left, at the same time
gently push a bit (Turn and Push). The fuse will come out.
3. Remove the used fuse. If brown or unclear, it is burned out.
4. Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover. Be sure to
use a fuse of the same type and specification. See the product specification label for details.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
If the DJ Switch does not operate properly, refer servicing to a technician. If the fuse is burned out,
replace the broken fuse with a new one, with the same specifications.
Response: Suspect two potential problem areas: the power supply or the fuse.
1. Power supply. Check that the unit is plugged into an appropriate power supply.
2. The fuse. See page 6 for the fuse.
Product Specification
Model: Showtec DJ Switch 10
Voltage: AC 230V-50Hz (CE)
Channel Output: 10A/CH.
Dimensions: 482x135x120mm (LxWxH)
19 inch; 3HE
Weight: 3,34kg
Design and product specifications are subject to change without prior notice.
Website: www.Showtec.info
Email: [e-mail]