Product guide

Settings

Enter the setting mode

Press the SETUP button (11) for 5 seconds while no program running, relevant LED will light up.

LCD will show you:

1. CF-CARD

2. ASSIGN CH.

(3.P/T FADE ONLY 4.DISPLAY MODE 5.MIDI CH. )

Use the UP/DOWN buttons (17 & 18)

to scroll, RECORD (15) to enter, and ESC (16) to exit.

Save data to the CF card

Enter the setting mode, then choose “1. CF-CARD” and press RECORD button (15), the LCD will show:

1. READ FROM CF

2. STORE TO CF

Then please press UP/DOWN (17 & 18) to choose “2. STORE TO CF”, press RECORD (15) again for

further operation.

Select relevant location (1-99) by UP/DOWN buttons to save the data, and then press the RECORD button

(15) for recording, press the ESC button (16) to exit.

Read from the CF card

Enter the setting mode, then choose “1. CF-CARD” and press RECORD, the LCD will show you:

1. READ FROM CF

2. STORE TO CF

Use UP/DOWN buttons to choose “1. READ FROM CF”, and press the RECORD button (15) to enter.

Select relevant location (1-99) by UP/DOWN buttons (17 & 18), and press the RECORD button (15) for data

reading, use ESC (16) to cancel or exit.

Patch channel (assign)

Enter the setting mode to choose “2. ASSIGN CH.” and press RECORD (15) to enter channel distributing

mode. LCD shows:

CHANNEL1 > OUT1

OK ESC SEL ADJ

Select the fixtures to be distributed.

Use UP button to select relevant channel number, and press DOWN to select the channel number to be

distributed.

Press RECORD button (15) to confirm, and press ESC button (16) to cancel or exit.