Product guide

10
Record a Chase
1) Enter Record Mode by pressing the Record button.
2) Select the proper Page by pressing the Page button.
3) Select the desired chase by pressing Chase button 1-8.
4) Select the desired fixture by pressing Fixture 1-4.
5) Set the faders to the desired values.
6) Press the Record button. All LEDs will flash 3 times, indicating your operation has been successful.
7) The display will show 01, meaning Step 1 in your chase has been recorded.
8) For further steps repeat 5, 6 and 7, until you have completed all the desired steps in your entire chase.
9) Exit Record Mode.
More than 1 fixture can be programmed/selected when creating steps.
Playing a Chase
1) Deselect all fixtures. All LEDs next to the 4 fixture buttons must be OFF.
2) Select your desired chase by pressing the Chase button.
Delete a Chase
1) Enter Record Mode by pressing the Record button.
2) Select the proper Page by pressing the Page button.
3) Press and hold the Tap Sync button. Now press the corresponding Chase button that you want to
delete.
4) Exit Record Mode by pressing the Record button.
Add an extra Step to an existing Chase
1) Enter Record Mode by pressing the Record button.
2) Select the chase you want to add a step to.
3) Use the Mode/Up and Patch/Down buttons to scroll through the chase. The display will show the
current step.
4) Select the fixture you want to program by pressing the desired Fixture button.
5) Set the faders to the desired values.
6) Press the Record button to save a new step. All LEDs will flash 3 times, indicating your operation has
been successful.
7) If you want to add additional steps repeat 4, 5 and 6, until you have added all the desired steps in your
entire chase.
8) Exit Record Mode.
There is a maximum of 99 steps in 1 chase
16 chases can hold a maximum of 392 steps
Delete a Step from an existing Chase
1) Enter Record Mode by pressing the Record button.
2) Select the chase from which you want to delete a step.
3) Use the Mode/Up and Patch/Down buttons to scroll through the chase and select the step you want
to delete.
4) Push the Tap Sync button to delete the step.
All LEDs will flash 3 times, indicating the stephas been successfully deleted.
5) Continue this procedure (steps 2, 3 and 4) if you want to delete multiple steps.
If you are finished deleting the steps , press Record Mode to exit Record Mode.