Product guide

9
Shaping the beam
You may shape the beam with the shutters, a pattern, an optional drop-in iris, or by rotating the barrel.
Pattern Projection
The pattern holder slot is on the top side of the barrel and in front of the shutters. It accommodates A-size,
B-size and glass pattern holders (Fig.10).
Fig. 10
Note: Because the Multi Profile S|pot is 3 inches wide, you can use A-size patterns for maximum pattern
effectiveness.
Use an optional donut in the accessory holder to enhance pattern projection.
Drop-in Iris-Slot
The Drop-in Iris slot is located on the top of the barrel and in front of the pattern holder slot. It
accommodates either a drop-in iris or a motorized pattern device. When the slot is not in use, a small sheet
metal cover secured with 2 screws prevents light leakage (Fig.11).
1. Use a scredriver to loosen the screws on ht edrop-in iris slot cover. Do not remove the screws.
2. Slide the cover completely forward to expose the slot.
3. Insert the iris or motorized pattern device. For an iris, install the flat side towards the shutters and make
sure that the iris handle extends from the slot.
4. Slide the slot cover back towards the shutters, until it meets the iris handle. Leave enough space to move
the iris handle.
5. Secure the drop-in iris slot cover by tightening the screws.
Fig. 11