Product guide

3
• Always disconnect power from the mains, when device is not used, before cleaning or when
replacing lamp! Only handle the power-cord by the plug. Never pull out the plug by tugging the
power-cord.
• Make sure that the device is not exposed to extreme heat, moisture or dust.
• Make sure that the available voltage is not higher than stated on the rear panel.
• Make sure that the power-cord is never crimped or damaged. Check the device and the power-cord
from time to time.
• Make sure that no side forces can impact on the truss system.
• Make sure that the core diameter of extension cords and power cords is sufficient for the required
power consumption of the device.
• The Studiobeam must be installed onto truss systems via the mounting bracket.
• The cable insert or the female part in the device must never be strained. There must always be
sufficient cable to the device. Otherwise, the cable may be damaged which may lead to deadly
electrical shocks.
• If the external cable is damaged, it has to be replaced by a qualified technician.
• If the lens or glass is obviously damaged, it has to be replaced. So that its functions are not
impaired, due to cracks or deep scratches.
• If device is dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
• If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your device. Leave the
device switched off until it has reached room temperature.
• If your Showtec device fails to work properly, discontinue use immediately. Pack the unit securely
(preferably in the original packing material), and return it to your Showtec dealer for service.
• For adult use only. Light effect must be installed out of the reach of children. Never leave the unit
running unattended.
• For replacement use lamps and fuses of same type and rating only.
• Allow time to cool down, before replacing lamp.
• The user is responsible for correct positioning and operating of the Studiobeam. The manufacturer
will not accept liability for damages caused by the misuse or incorrect installation of this device.
• This device falls under protection class I. Therefore it is essential to connect the yellow/green
conductor to earth.
• To ensure the longest and most efficient use of the lamp always wait 15 minutes before re-applying
power after a shutdown. Failure to do so could result in premature aging of the lamp and failure to
the electronics that drive it.
• Replace the lamp if it becomes defective or worn out, or before usage exceeds the maximum service
life.
• During the initial start-up some smoke or smell may arise. This is a normal process and does not
necessarily mean that the device is defective.
• Repairs, servicing and electric connection must be carried out by a qualified technician.
• WARRANTY: Till one year after date of purchase.
CAUTION ! EYEDAMAGES !.
Avoid looking directly into the light source.
(
meant es
p
eciall
y
for e
p
ile
p
tics
)
!