Product guide

7
Installation
Installing the Lamp
The Showtec Studio Beam uses a MSR 575W (ordercode 80915 / 80915O / 80923) bulbs as manufactured
by all popular manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Procedure :
1. Disconnect from main power supply, and let the Studiobeam cool down for 15 minutes.
2. Loosen the knurled bolt on the back of the lamp housing and pull the housing straight out from the fixture.
3. Read lamp instructions. Do not touch the lamp bulb glass. Oil on hands shortens the lamp life. (If you
touch the bulb glass, wipe off the glass with a clean, lint-free towel and rubbing alcohol.).
4. Line up the flat sides of the lamp base with the brackets on either side of the socket (Fig. 3).
5. Insert the lamp pins into the small holes in the lamp socket. Be sure that the lamp is pushed all the way
down.
6. Put the lampcover back, by centering it on the reflector and the bolthole. Then fasten the knurled bolt
again.
Fig. 3
Lens Identification
Lenses for the Studiobeam are available in 4 versions. The type or beam angle can be identified by the lens
texture.
Fig. 4