User's Manual
Table Of Contents
- Table of Contents
- AD2Handheld Transmitter
- WARNING
- AD2 Handheld Transmitter
- Features
- Included Components
- Optional Accessories
- AD2 Transmitter Overview
- Transmitter Controls
- Home Screen Display
- Locking the Interface
- Battery Installation
- Installing the Battery Contact Cover
- Installing the Battery Contact Cover
- Shure SB900A Rechargeable Battery
- Menu Parameters
- Menu Parameter Descriptions
- IR Sync
- Setting the Frequency Manually
- Updating Firmware
- RF Mute
- Safe Start
- Input Overload
- Tone Generator
- Matching Audio Levels with Offset
- Specifications
- Frequency Bands and Transmitter RF Power
- LICENSING INFORMATION
- Australia Warning for Wireless
- Certifications
- Contact Customer Support
Shure Incorporated
14/25
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
1.
2.
Transmitter will generate a continuous test tone:
Freq: The tone can be set to 400 Hz or 1000 Hz.
Level: Adjusts the output level of the test tone.
Utilities Menu
Device ID
Assign a device ID of up to 9 letters or numbers.
Locks
Locks the transmitter controls and power switch.
None: The controls are unlocked
Power: The power switch is locked
Menu: The menu parameters are locked
All: The power switch and menu parameters are locked
Marker
When enabled, press the enter button to drop a marker in Wireless Workbench.
Battery
Displays battery information:
Battery Life: Runtime reported in bar display and time (hours:minutes)
Charge: Percentage of charge capacity
Health: Percentage of current battery health
Cycle Count: Total of the number of charging cycles for the installed battery
Temperature: Battery temperature reported in Celsius and Fahrenheit
About
Displays the following transmitter information:
Model: Displays the model number
Band: Displays the tuning band of the transmitter
FW Version: Installed firmware
HW Version: Hardware version
Serial Num: Serial number
Reset All
Restores all transmitter parameters to factory settings.
IR Sync
Use IR Sync to form an audio channel between the transmitter and receiver.
Note: The receiver band must match the band of the transmitter.
Select a receiver channel.
Tune the channel to an available frequency using group scan or manually turn to an open frequency.