User's Manual
Table Of Contents
- Table of Contents
- AD2Handheld Transmitter
- WARNING
- AD2 Handheld Transmitter
- Features
- Included Components
- Optional Accessories
- AD2 Transmitter Overview
- Transmitter Controls
- Home Screen Display
- Locking the Interface
- Battery Installation
- Installing the Battery Contact Cover
- Installing the Battery Contact Cover
- Shure SB900A Rechargeable Battery
- Menu Parameters
- Menu Parameter Descriptions
- IR Sync
- Setting the Frequency Manually
- Updating Firmware
- RF Mute
- Safe Start
- Input Overload
- Tone Generator
- Matching Audio Levels with Offset
- Specifications
- Frequency Bands and Transmitter RF Power
- LICENSING INFORMATION
- Australia Warning for Wireless
- Certifications
- Contact Customer Support
Shure Incorporated
16/25
1.
2.
3.
4.
Firmware Versioning
When performing an update, first download firmware to the receiver, and then update transmitters to the same firmware version
to ensure consistent operation.
The firmware numbering for Shure devices uses the following format: MAJOR.MINOR.PATCH (e.g., 1.2.14). At a minimum, all
devices on the network (including transmitters), must have the same MAJOR and MINOR firmware version numbers (e.g.,
1.2.x).
Updating the Transmitter
Download the firmware to the receiver.
Access the following menu from the receiver: Device Configuration > Tx Firmware Update.
Align the IR ports between the transmitter and the receiver. IR ports must be aligned for the entire download, which can
take 50 seconds or longer.
The red alignment LED will turn on when the alignment is correct.
Press ENTER on the receiver to begin the download to the transmitter. The receiver will display the progress of the up
date as a percentage.
RF Mute
RF Mute prevents transmission of the audio by suppressing the RF signal while allowing the transmitter to remain on. The
home screen displays RF MUTED in this mode.