User's Manual
Table Of Contents
- Table of Contents
- AD2Handheld Transmitter
- WARNING
- AD2 Handheld Transmitter
- Features
- Included Components
- Optional Accessories
- AD2 Transmitter Overview
- Transmitter Controls
- Home Screen Display
- Locking the Interface
- Battery Installation
- Installing the Battery Contact Cover
- Installing the Battery Contact Cover
- Shure SB900A Rechargeable Battery
- Menu Parameters
- Menu Parameter Descriptions
- IR Sync
- Setting the Frequency Manually
- Updating Firmware
- RF Mute
- Safe Start
- Input Overload
- Tone Generator
- Matching Audio Levels with Offset
- Specifications
- Frequency Bands and Transmitter RF Power
- LICENSING INFORMATION
- Australia Warning for Wireless
- Certifications
- Contact Customer Support
Shure Incorporated
19/25
1.
2.
3.
1.
2.
3.
From the Audio menu select Tone Gen.
Set the frequency to 400 Hz or 1000 Hz.
Select Level and use the arrow buttons adjust the value between -60 dB and 0 dB.
Turn off the tone by selecting Off from the menu or by cycling the transmitter power.
Matching Audio Levels with Offset
When linking two or more transmitters to a receiver, there may be a difference in volume levels between microphones or instru
ments. If this occurs, use the Offset function to match the audio levels and eliminate audible volume differences between trans
mitters. If using a single transmitter, set Offset to 0 dB.
Turn on the first transmitter and perform a sound check to test the audio level. Turn off the transmitter when finished.
Turn on the second transmitter and perform a sound check to test the audio level. Repeat for any additional transmit
ters.
If there is an audible difference in the sound level between the transmitters, navigate to the Offset menu (Audio >
Offset) in the transmitter to increase or decrease the Offset in realtime to match the audio levels.