User's Manual
Table Of Contents
- Table of Contents
- AD3 Plug-On Transmitter
- WARNING
- AD3 Axient Digital Plug-On Transmitter
- Included Components
- Optional Accessories
- AD3 Transmitter Overview
- Setup
- Setting the AA Battery Type
- Transmitter Controls
- Menu Overview
- Home Screen Display
- Locking the Interface
- IR Sync
- Setting the Frequency Manually
- Updating Firmware
- RF Mute
- Safe Start
- Input Overload
- Input Overload
- Tone Generator
- Matching Audio Levels with Offset
- Menu Item Descriptions
- Specifications
- Mic Offset Range
- Battery Type
- Battery Runtime
- Dimensions
- Weight
- Housing
- Operating Temperature Range
- Storage Temperature Range
- Audio Input
- Connector
- Configuration
- Impedance
- Maximum Input Level
- Preamplifier Equivalent Input Noise (EIN)
- Phantom Power
- High Pass Filter
- RF Output
- Antenna Type
- Impedance
- Occupied Bandwidth
- Channel-to-Channel Spacing
- Modulation Type
- Power
- Specific Absorption Rate (SAR)
- Frequency Bands and Transmitter RF Power
- LICENSING INFORMATION
- Certifications
- Contact Customer Support
Shure Incorporated
16/23
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
Selectable polarity assignment for the audio input connector:
Pos: Positive pressure on microphone diaphragm produces positive voltage on pin 2 (with respect to pin 3 of XLR output)
and the tip of the TRS output on the receiver.
Neg: Positive pressure on microphone diaphragm produces negative voltage on pin 2 (with respect to pin 3 of XLR output)
and the tip of the TRS output on the receiver.
Offset
Adjust Offset level to balance mic levels when using two transmitters or when assigning multiple transmitters to receiver
slots. Adjustment range: -12 dB to +21 dB.
Tone Gen
Tone generator. Transmitter will generate a continuous test tone:
Freq: The tone can be set to 400 Hz or 1000 Hz.
Level: Adjusts the output level of the test tone.
Utilities Menu
Device ID
Assign a device ID of up to 8 characters.
Locks
Locks the transmitter controls and power switch.
None: The controls are unlocked
Power: The power switch is locked
Menu: The menu parameters are locked
All: The power switch and menu parameters are locked
Marker
When enabled, press O to drop a marker in Wireless Workbench.
Battery
Displays battery information:
Battery Life: Runtime reported in bar display and time (hours:minutes)
Battery Time to Full (only appears when Shure rechargeable battery is being externally charged): Time remaining until bat
tery is fully charged
Charge: Percentage of charge capacity
Health: Percentage of current battery health
Cycle Count: Total of the number of charging cycles for the installed battery
Temperature: Battery temperature reported in Celsius and Fahrenheit
About
Displays the following transmitter information:
Model: Displays the model number
Band: Displays the tuning band of the transmitter
FW Version: Installed firmware
HW Version: Hardware version