User's Manual
Table Of Contents
- Table of Contents
- AD4DDual Channel Receiver
- IMPORTANT SAFETY INSTRUCTIONS
- Australia Warning for Wireless
- AD4D Axient Digital Two-Channel Wireless Receiver
- Included Components
- Mounting Instructions
- Hardware
- Menus and Configuration
- Radio Frequency (RF) Settings
- Setting the RF Tuning Band
- IR Sync
- Setting the Frequency Manually
- Channel Scan and Group Scan
- Requesting a New Frequency from a Spectrum Manager
- Transmission Modes
- Assigning Transmitters to Transmitter Slots
- Interference Management
- Channel Quality Meter
- Frequency Diversity
- Antenna Bias
- RF Cascade Ports
- Firmware
- Audio Settings
- Networking
- Operation
- Troubleshooting
- Specifications
- System Specifications
- RF Carrier Frequency Range
- Working Range
- RF Tuning Step Size
- Channel-to-Channel Spacing
- Channel-to-Channel Spacing
- Image Rejection
- RF Sensitivity
- Latency Analog Output
- Audio Frequency Response
- Signal-to-Noise Ratio(Dynamic Range)
- Total Harmonic Distortion
- System Audio Polarity
- Operating Temperature Range
- Storage Temperature Range
- Audio Output
- Gain Adjustment Range
- Configuration
- Impedance
- Full Scale Output (200K Ω load)
- Mic/Line Switch
- Phantom Power Protection
- Dimensions
- Weight
- Housing
- Power Requirements
- Thermal Power Dissipation
- DC Power Requirements
- Network Interface
- Network Addressing Capability
- Maximum Cable Length
- Cascade Output
- Connector Type
- Configuration
- Impedance
- Insertion Loss
- RF Input
- Spurious Rejection
- Connector Type
- Impedance
- Bias Voltage
- RF Carrier Frequency Range model dependent
- Tables and Diagrams
- Receiver Frequency Bands
- Certifications
- Certifications
- Contact Customer Support
Shure Incorporated
2/41
Table of Contents
AD4DDual Channel Receiver 4
IMPORTANT SAFETY INSTRUCTIONS 4
Australia Warning for Wireless 5
AD4D Axient Digital Two-Channel Wireless Receiver 5
Features 5
Included Components 6
Mounting Instructions 6
Hardware 7
Receiver Front Panel 7
Receiver Back Panel 9
Menus and Configuration 10
Accessing the Device Configuration Menu or Channel
Menus 11
Home Screen 11
Screen Icons 11
Device Configuration Menu and Parameters 12
AD4D Device Configuration Parameters 13
Channel Menu Parameters 17
Radio Frequency (RF) Settings 19
Setting the RF Tuning Band 19
IR Sync 19
Setting the Frequency Manually 20
Channel Scan and Group Scan 20
Requesting a New Frequency from a Spectrum Manager 2
1
Transmission Modes 21
Assigning Transmitters to Transmitter Slots 22
Interference Management 23
Channel Quality Meter 23
Frequency Diversity 24
Antenna Bias 24
RF Cascade Ports 25
Firmware 25
Audio Settings 26
Adjusting Channel Gain and Audio Output 26
Tone Generator 27
Headphone Monitoring 27
System Gain 28
Networking 28
Networking Receivers 28
Network Browser 30
Network Troubleshooting 30
Operation 31
Assigning a Device ID 31
Assigning a Channel Name 31
Locking and Unlocking the Controls 31
Display Screen Options 31
Saving Receiver Settings as User Presets 32
Programming Transmitters Using IR Presets 32
Encryption 33
Restoring the Receiver to Factory Settings 33
Cooling Fan 33
Troubleshooting 34
Power 34
Gain 34
Cables 34
Interface Locks 34
Encryption Mismatch 34
Firmware Mismatch 34
Radio Frequency (RF) 34