User's Manual
Table Of Contents
- Table of Contents
- AD4DDual Channel Receiver
- IMPORTANT SAFETY INSTRUCTIONS
- Australia Warning for Wireless
- AD4D Axient Digital Two-Channel Wireless Receiver
- Included Components
- Mounting Instructions
- Hardware
- Menus and Configuration
- Radio Frequency (RF) Settings
- Setting the RF Tuning Band
- IR Sync
- Setting the Frequency Manually
- Channel Scan and Group Scan
- Requesting a New Frequency from a Spectrum Manager
- Transmission Modes
- Assigning Transmitters to Transmitter Slots
- Interference Management
- Channel Quality Meter
- Frequency Diversity
- Antenna Bias
- RF Cascade Ports
- Firmware
- Audio Settings
- Networking
- Operation
- Troubleshooting
- Specifications
- System Specifications
- RF Carrier Frequency Range
- Working Range
- RF Tuning Step Size
- Channel-to-Channel Spacing
- Channel-to-Channel Spacing
- Image Rejection
- RF Sensitivity
- Latency Analog Output
- Audio Frequency Response
- Signal-to-Noise Ratio(Dynamic Range)
- Total Harmonic Distortion
- System Audio Polarity
- Operating Temperature Range
- Storage Temperature Range
- Audio Output
- Gain Adjustment Range
- Configuration
- Impedance
- Full Scale Output (200K Ω load)
- Mic/Line Switch
- Phantom Power Protection
- Dimensions
- Weight
- Housing
- Power Requirements
- Thermal Power Dissipation
- DC Power Requirements
- Network Interface
- Network Addressing Capability
- Maximum Cable Length
- Cascade Output
- Connector Type
- Configuration
- Impedance
- Insertion Loss
- RF Input
- Spurious Rejection
- Connector Type
- Impedance
- Bias Voltage
- RF Carrier Frequency Range model dependent
- Tables and Diagrams
- Receiver Frequency Bands
- Certifications
- Certifications
- Contact Customer Support
Shure Incorporated
33/41
1.
2.
3.
4.
1.
2.
1.
2.
◦
◦
Encryption
The receiver features Advanced Encryption Standard (AES-256) to ensure that only the receiver that is keyed to the transmitter
can monitor the audio content.
Note: When enabled, encryption is applied to all receiver channels. Encryption does not affect Dante audio signals, audio quality, or channel spacing.
From the Device Configuration menu: Device RF > Encryption.
Use the control wheel to select On.
Press ENTER to save.
Perform an IR sync to complete the encryption between the transmitter and the receiver. The encryption key icon will
appear on the display of both the receiver and the transmitter.
Note:
Any change to the encryption status on the receiver such as enabling/ disabling encryption or requesting a new encryp
tion key, requires a sync to send the settings to the transmitter.
Tip: To remove encryption, use the control wheel to select Off and re-sync the transmitter to clear the encryption.
Restoring the Receiver to Factory Settings
The Factory Reset function clears the current settings and restores the factory settings.
Caution: All current settings will be cleared during the reset and the receiver will need to reboot.
From the Device Component menu: Factory Reset
Press ENTER to reset the receiver, or press EXIT to return to the Device Configuration menu.
Cooling Fan
The receiver contains an internal cooling fan to protect against over-temperature conditions.
From the Device Configuration menu: Fan
Select from the following fan setting options:
Auto: The fan will automatically turn on if the receiver temperature rises
On: The fan will run continuously to offer maximum cooling in warm environments
Tip: The internal receiver temperature is shown on the Fan display screen.