User's Manual
Table Of Contents
- Table of Contents
- AD4DDual Channel Receiver
- IMPORTANT SAFETY INSTRUCTIONS
- Australia Warning for Wireless
- AD4D Axient Digital Two-Channel Wireless Receiver
- Included Components
- Mounting Instructions
- Hardware
- Menus and Configuration
- Radio Frequency (RF) Settings
- Setting the RF Tuning Band
- IR Sync
- Setting the Frequency Manually
- Channel Scan and Group Scan
- Requesting a New Frequency from a Spectrum Manager
- Transmission Modes
- Assigning Transmitters to Transmitter Slots
- Interference Management
- Channel Quality Meter
- Frequency Diversity
- Antenna Bias
- RF Cascade Ports
- Firmware
- Audio Settings
- Networking
- Operation
- Troubleshooting
- Specifications
- System Specifications
- RF Carrier Frequency Range
- Working Range
- RF Tuning Step Size
- Channel-to-Channel Spacing
- Channel-to-Channel Spacing
- Image Rejection
- RF Sensitivity
- Latency Analog Output
- Audio Frequency Response
- Signal-to-Noise Ratio(Dynamic Range)
- Total Harmonic Distortion
- System Audio Polarity
- Operating Temperature Range
- Storage Temperature Range
- Audio Output
- Gain Adjustment Range
- Configuration
- Impedance
- Full Scale Output (200K Ω load)
- Mic/Line Switch
- Phantom Power Protection
- Dimensions
- Weight
- Housing
- Power Requirements
- Thermal Power Dissipation
- DC Power Requirements
- Network Interface
- Network Addressing Capability
- Maximum Cable Length
- Cascade Output
- Connector Type
- Configuration
- Impedance
- Insertion Loss
- RF Input
- Spurious Rejection
- Connector Type
- Impedance
- Bias Voltage
- RF Carrier Frequency Range model dependent
- Tables and Diagrams
- Receiver Frequency Bands
- Certifications
- Certifications
- Contact Customer Support
Shure Incorporated
40/41
Receiver Frequency Bands
Band Frequency Range (MHz)
G53 470 to 510
G54 479 to 565
G55† 470 to 636*
G56 470 to 636
G57 (G57+) 470 to 616* (614 to 616*** )
G62 510 to 530
H54 520 to 636
K53 606 to 698*
K54 606 to 663**
K55 606 to 694
K56 606 to 714
K57 606 to 790
K58 622 to 698
L54 630 to 787
P55 694 to 703, 748 to 758, 803 to 806
R52 794 to 806
JB 806 to 810
X51 925 to 937.5
X55 941 to 960
Z16†† 1240 to 1260
*with a gap between 608 to 614 MHz.
**with a gap between 608 to 614 MHz and a gap between 616 to 653 MHz.
***selecting the G57+ band extends the G57 band with 2 MHz of additional spectrum between 614 to 616 MHz. Maximum
transmitter power is limited to 10mW between 614 to 616 MHz.
†operation mode varies according to region. In Brazil, High Density mode is used.
††Z16 for Japan only
เครื่องโทรคมนาคมและอุปกรณ์นี้มีความสอดคล้องตามมาตรฐานหรือข้อกำหนดทางเทคนิคของ กสทช.