User Manual
Shure Incorporated
29/40
•
•
1.
2.
3.
4.
1.
2.
3.
1.
2.
3.
1.
2.
3.
•
•
•
•
The Dante Controller is a free software program created by Audinate to configure and manage networks of Danteen
abled devices. Use the Controller to create audio routes between networked components and to monitor the status of on
line devices.
Networking Modes and Switch Configuration
The receiver offers two selectable networking modes:
Split/Redundant: This mode places Dante audio and Shure control on separate networks, while allowing you to take ad
vantage of Dante redundancy.
Switched: In Switched mode, the receiver acts as a 4-port network switch. Shure control and Dante audio are present on
all network ports.
From the factory, the receiver is configured to Split/Redundant mode.
To Configure the switch mode:
Device
Configuration > Network
Configuration.
Select Setup to enter the Switch Configuration menu.
Use the control wheel to change the mode.
Press ENTER to reboot the receiver and change the mode.
IP Address Configuration
An IP address must be assigned to each device in the network to ensure communication and control between components.
Valid IP addresses can be assigned automatically using a DHCP server or manually from a list of valid IP addresses. If using
Dante audio, a separate Dante IP address must also be assigned to the receiver.
Automatic IP Addressing Mode
If using a DHCP capable Ethernet switch, set the DHCP switch to ON.
From the Device Configuration menu: Network
Configuration > Next
Press the control wheel to enable editing of the Mode, and then set the mode to Automatic.
Manual IP addressing Mode
From the Device Configuration menu: Network
Configuration > Next
Press the control wheel to enable editing of the Mode, and then set the mode to Manual
Set valid IP addresses and subnet values, and then press ENTER to save.
Network Browser
The network browser allows you to discover other devices connected to your network. You can view information about the dis
covered devices, including Device ID, IP address, firmware version, and model name.
From the Device Configuration menu: Network Browser
When selected, the Network Browser will discover and list devices on the network.
Use the control wheel to scroll through and select devices.
The following information and actions are available from the Network Browser:
Show: Selects the device from the list
Flash: Flashes front panel LEDs
Info: Displays the device ID, model, IP address, and firmware version
Flash All: Flashes the front panel of all devices
™