User Manual

Shure Incorporated
35/40
•
•
•
•
•
•
•
Eliminating RF Overload
If you see the red RF LED on a receiver, try the following:
Reduce the transmitter RF power level
Move the transmitter further away from the receiver—at least 6 m (20 ft)
If you are using active antennas, reduce antenna or amplifier gain.
Use omnidirectional antennas
Antenna Faults
The Antenna Fault red LED indicates a short circuit condition or excessive load at an antenna port.
Check antennas and cables for damage
Ensure that antenna ports are not overloaded
Check antenna bias voltage setting. Turn off voltage if using passive antennas.
Specifications
System Specifications
RF Carrier Frequency Range
470–960 MHz, varies by region (See frequency table)
Working Range
100 m (330 ft)
Note: Actual range depends on RF signal absorption, reflection and interference.
RF Tuning Step Size
25 kHz, varies by region
Channel-to-Channel Spacing
Standard Mode 350 kHz
High Density Mode 125 kHz
varies by region
Image Rejection
>70 dB, typical
RF Sensitivity
−98 dBm at 10 BER
-5
Latency Analog Output
STD 2.08 ms
HD 2.96 ms