User Manual
Table Of Contents
- Table of Contents
- ADX1MBodypack Transmitter
- WARNING
- ADX1M Axient Digital Micro Bodypack Transmitter
- Included Components
- Optional Accessories
- ADX1M Transmitter Overview
- Home Screen Display
- Transmitter Controls
- Locking the Interface
- Shure Rechargeable Batteries
- Menu Parameters
- Menu Parameter Descriptions
- IR Sync
- Setting the Frequency Manually
- RF Mute
- Safe Start
- Wearing the Bodypack Transmitter
- Input Overload
- Matching Audio Levels with Mic Offset
- Tone Generator
- Tone Generator
- ShowLink Test
- Updating Firmware
- Specifications
- Mic Offset Range
- Battery Type
- Battery Runtime
- Dimensions
- Weight
- Housing
- Operating Temperature Range
- Storage Temperature Range
- Audio Input
- Connector
- Configuration
- Impedance
- Maximum Input Level
- Preamplifier Equivalent Input Noise (EIN)
- RF Output
- Antenna Type
- Impedance
- Occupied Bandwidth
- Channel-to-Channel Spacing
- Modulation Type
- Power
- ShowLink
- Network Type
- Antenna Type
- Frequency Range
- RF Output Power
- Input Connector Diagram
- Frequency Bands and Transmitter RF Power
- Australia Warning for Wireless
- Certifications
Shure Incorporated
10/22
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
Mute: RF signal is inactive
Audio Menu
Offset
Adjust Offset level to balance mic levels when using two transmitters or when assigning multiple transmitters to receiver
slots. Adjustment range: -12 dB to +21 dB.
Polarity
Selectable polarity assignment for audio input connector:
Pos: Positive pressure on microphone diaphragm produces positive voltage on pin 2 (with respect to pin 3 of XLR output)
and the tip of the TRS output.
Neg: Positive pressure on microphone diaphragm produces negative voltage on pin 2 (with respect to pin 3 of XLR output)
and the tip of the TRS output.
Mute
When enabled, the power button is configured as a mute switch for the audio output. Press the power button to mute or
un-mute the audio. Exit mute mode to return the power button to its normal functionality.
Tone Gen
Transmitter will generate a continuous test tone:
Freq: The tone can be set to 400 Hz or 1000 Hz.
Level: Adjusts of the output level of the test tone.
Utilities Menu
Device ID
Assign a device ID of up to 9 letters or numbers.
Locks
Locks the transmitter controls and power button.
None: The controls are unlocked
Power: The power switch is locked
Menu: The menu parameters are locked
All: The power button and menu parameters are locked
Link Info
Displays the following information about the link between a transmitter and receiver:
Not Linked: The transmitter is not linked to a receiver
Linked: The transmitter is linked to a receiver. Select Unlink? to free the transmitter from the receiver link.
Unlinked: The transmitter is not linked to a receiver
SL Test
ShowLink test tool to measure the boundaries of ShowLink coverage.
Marker