User Manual
Table Of Contents
- Table of Contents
- ADX1MBodypack Transmitter
- WARNING
- ADX1M Axient Digital Micro Bodypack Transmitter
- Included Components
- Optional Accessories
- ADX1M Transmitter Overview
- Home Screen Display
- Transmitter Controls
- Locking the Interface
- Shure Rechargeable Batteries
- Menu Parameters
- Menu Parameter Descriptions
- IR Sync
- Setting the Frequency Manually
- RF Mute
- Safe Start
- Wearing the Bodypack Transmitter
- Input Overload
- Matching Audio Levels with Mic Offset
- Tone Generator
- Tone Generator
- ShowLink Test
- Updating Firmware
- Specifications
- Mic Offset Range
- Battery Type
- Battery Runtime
- Dimensions
- Weight
- Housing
- Operating Temperature Range
- Storage Temperature Range
- Audio Input
- Connector
- Configuration
- Impedance
- Maximum Input Level
- Preamplifier Equivalent Input Noise (EIN)
- RF Output
- Antenna Type
- Impedance
- Occupied Bandwidth
- Channel-to-Channel Spacing
- Modulation Type
- Power
- ShowLink
- Network Type
- Antenna Type
- Frequency Range
- RF Output Power
- Input Connector Diagram
- Frequency Bands and Transmitter RF Power
- Australia Warning for Wireless
- Certifications
![](/manual/shure/adx1m-g57/user-manual-english/images/img-11.png)
Shure Incorporated
11/22
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
1.
2.
3.
4.
5.
When enabled, press the enter button to drop a marker in Wireless Workbench.
Battery
Displays battery information:
Battery Life: Runtime reported in bar display and time (hours:minutes)
Charge: Percentage of charge capacity
Health: Percentage of current battery health
Cycle Count: Total of the number of charging cycles for the installed battery
Temperature: Battery temperature reported in Celsius and Fahrenheit
Talk Sw
Press ENTER to add control from a talk switch. Press the button on the talk switch twice to complete the link.
Identify
When enabled, Identify flashes the transmitter icon in Wireless Workbench Inventory or Monitor tabs.
Btn Help
A graphic identifying each button appears when the device is turned on. Use the Btn Help menu to turn the graphic On or Off.
About
Displays the following transmitter information:
Model: Displays the model number
Band: Displays the tuning band of the transmitter
FW Version: Installed firmware
HW Version: Hardware version
Serial Num: Serial number
Reset All
Restores all transmitter parameters to factory settings.
IR Sync
Use IR Sync to form an audio channel between the transmitter and receiver.
Note: The receiver band must match the band of the transmitter.
Select a receiver channel.
Tune the channel to an available frequency using group scan or manually turn to an open frequency.
Power on the transmitter.
Press the SYNC button on the receiver.
Align the IR windows between the transmitter and the receiver so that the IR LED illuminates red. When complete,
Sync Success! appears. The transmitter and receiver are now tuned to the same frequency.