User Manual
Table Of Contents
- Table of Contents
- ADX1MBodypack Transmitter
- WARNING
- ADX1M Axient Digital Micro Bodypack Transmitter
- Included Components
- Optional Accessories
- ADX1M Transmitter Overview
- Home Screen Display
- Transmitter Controls
- Locking the Interface
- Shure Rechargeable Batteries
- Menu Parameters
- Menu Parameter Descriptions
- IR Sync
- Setting the Frequency Manually
- RF Mute
- Safe Start
- Wearing the Bodypack Transmitter
- Input Overload
- Matching Audio Levels with Mic Offset
- Tone Generator
- Tone Generator
- ShowLink Test
- Updating Firmware
- Specifications
- Mic Offset Range
- Battery Type
- Battery Runtime
- Dimensions
- Weight
- Housing
- Operating Temperature Range
- Storage Temperature Range
- Audio Input
- Connector
- Configuration
- Impedance
- Maximum Input Level
- Preamplifier Equivalent Input Noise (EIN)
- RF Output
- Antenna Type
- Impedance
- Occupied Bandwidth
- Channel-to-Channel Spacing
- Modulation Type
- Power
- ShowLink
- Network Type
- Antenna Type
- Frequency Range
- RF Output Power
- Input Connector Diagram
- Frequency Bands and Transmitter RF Power
- Australia Warning for Wireless
- Certifications
Shure Incorporated
6/22
1.
◦
The following icons indicate transmitter settings:
Battery runtime in hours and minutes or bar display
Key: Displayed when encryption is enabled
Lock: Displayed when controls are locked. Icon will flash if
access is attempted to a locked control (power or menu).
ShowLink signal strength displays 0 to 5 bars
STD: Standard Transmission Mode
HD: High Density Transmission Mode
RF Mute Engaged: Displayed when RF output is muted
Transmitter Controls
Use the controls to navigate through parameter menus and change values.
∨∧ Use to scroll through menu screens and to change parameter values.
Acts as a back button to return to previous menus or parameters without confirming a value change.
O Enters menu screens and applies parameter changes.
Tip: Hold the ^ and buttons while powering on to activate RF Mute mode and enter the Safe Start menu.
Locking the Interface
Lock transmitter interface controls to prevent accidental or unauthorized changes to parameters. The lock icon appears on the
home screen when the interface lock is enabled.
From the Utilities menu, navigate to Locks and select one of the following lock options:
None: The controls are unlocked