User's Manual
Table Of Contents
- Table of Contents
- ADX2Handheld Transmitter
- WARNING
- ADX2 Handheld Transmitter
- Features
- Included Components
- Optional Accessories
- ADX2 Transmitter Overview
- Transmitter Controls
- Home Screen Display
- Home Screen Display
- Locking the Interface
- Shure Rechargeable Batteries
- Installing the Battery Contact Cover
- Menu Parameters
- Menu Parameter Descriptions
- IR Sync
- Setting the Frequency Manually
- RF Mute
- Safe Start
- Input Overload
- Tone Generator
- Matching Audio Levels with Mic Offset
- ShowLink Test
- Updating Firmware
- Specifications
- Mic Offset Range
- Battery Type
- Battery Runtime
- Dimensions
- Weight
- Housing
- Operating Temperature Range
- Storage Temperature Range
- Audio Input
- Configuration
- Maximum Input Level
- RF Output
- Antenna Type
- Occupied Bandwidth
- Channel-to-Channel Spacing
- Modulation Type
- Power
- Specific Absorption Rate (SAR)
- ShowLink
- Network Type
- Antenna Type
- Frequency Range
- RF Output Power
- Frequency Bands and Transmitter RF Power
- Australia Warning for Wireless
- Certifications
Shure Incorporated
12/24
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
Audio Menu
Offset
Adjust Offset level to balance mic levels when using two transmitters for frequency diversity or when assigning multiple
transmitters to receiver slots. Adjustment range: -12 dB to +21 dB.
Mute
When enabled, the power switch is configured as a mute switch for the audio:
Power switch on: audio signal on
Power switch off: audio signal muted
Tone Gen
Transmitter will generate a continuous test tone:
Freq: The tone can be set to 400 Hz or 1000 Hz.
Level: Allows for adjustment of the output level of the test tone.
Utilities Menu
Device ID
Assign a device ID of up to 9 letters or numbers.
Locks
Locks the transmitter controls and power switch.
None: The controls are unlocked
Power: The power switch is locked
Menu: The menu parameters are locked
All: The power switch and menu parameters are locked
Link Info
Displays the following information about the link between a transmitter and receiver:
Not Linked: The transmitter is not linked to a receiver
Linked: The transmitter is linked to a receiver. Select Unlink? to free the transmitter from the receiver link.
Unlinked: The transmitter is not linked to a receiver
SL Test
ShowLink test tool to measure the boundaries of ShowLink coverage.
Marker
When enabled, press the enter button to drop a marker in Wireless Workbench.
Battery
Displays battery information:
Battery Life: Runtime reported in bar display and time (hours:minutes)
Charge: Percentage of charge capacity
Health: Percentage of current battery health