System information

Chapter 24 ‒ Care and Maintenance of Cables and Connectors
Audio Connectors
Bodypack transmitters and their connectors are often subjected to intense sweat during performances. To maintain top
performance, periodically clean the audio input connectors (TA4F or LEMO) on the bodypack with an aerosol-based flux
remover. Most flux remover products come with a spray straw that inserts into the nozzle to apply the spray inside the
connector. Always wear protective safety glasses while using the flux remover.
To clean the bodypack audio connector, turn the bodypack upside down over a cloth or paper towel, insert the spray straw
just inside the connector, and gently spray several short bursts of the flux remover. It is important to keep the bodypack
transmitter held upside down to allow the flux remover to completely drain out of the connector. Use a cotton swab to wipe
any excess flux remover from the inside of the connector and a towel to clean the bodypack transmitter surface.
SMA Jacks
SMA jacks are used for RF transmission on the AXT100 Bodypack Transmitter, AXT200 Handheld Transmitter, and
AXT610 ShowLink Access Point. When tightening the male antenna, SMA connectors are designed to have a maximum
of 5-6 in-lbs of torque applied. Over-tightening can damage the connector and the antenna.
Cables
Damage to network and RF cables affects the performance of the signals they transport. Do not kink network or RF cables
while coiling them for storage.
Periodically inspect RF and network cables for the following damage:
• kinks
• cuts
• slices
• broken connectors or shields
• bent, broken, missing, or damaged pins
• damaged threads
146
Part 6: Care and Maintenance