System information

AXT610 ShowLink Access Point

Features

• Real-time wireless remote control of up to 16

transmitters per ShowLink access point

• Automated channel selection - Independently scans

2.4 GHz frequency range and determines best channel

for use

• Can be powered by a Power over Ethernet (PoE)

network connection or from an external power supply

• Easy transmitter authentication - Recognizes linked

transmitters upon IR sync

• Provides coverage area approximately the same as the

transmitter’s UHF range (depending on the RF squelch

setting of the receiver)

• Automatic hand-offs between multiple access points

extend coverage range

• Versatile mounting options - Fits readily available

microphone stand adapters and features built-in

threading for permanent installation

• Wireless Workbench 6 system supports networked

control of all device functions and provides a ShowLink

plot for viewing 2.4 GHz signal levels

The AXT610 ShowLink™ access point enables real-time remote control of the Axient™ transmitters. The access point

allows comprehensive management of transmitter parameters from the receiver or Wireless Workbench

6 using 2.4 GHz

wireless network communication. All parameter changes occur without interruption to the performer.

Multiple access points can extend the operational range or increase the number of transmitters supported on the

ShowLink network.

Part 1: Introduction