System information

4 Receiver Example
Tips
• Use antennas that match the bands of the receivers
• Use the RF cascade ports to share the RF signal between the AXT600 Spectrum Manager and the AXT400
receivers
• Use an AXT620 Ethernet Switch for network connections. Set the DHCP switch to ON before applying power.
• Connect each component to a port on the AXT620 Ethernet switch
• Connect the AXT610 ShowLink access point to a Power over Ethernet (PoE) enabled Ethernet port or external
power supply
• Remote control of transmitters is possible from WWB6 or from the front panel of the receiver
This example uses four AXT400 receivers to provide four Frequency Diversity audio channels or eight single audio
channels.
• The AXT620 is added to the system and configured as the DHCP server for the network
• All receivers are tuned to the same band and share the antenna signal using the RF cascade ports
• The AXT900 adds charging capacity for 8 transmitter batteries. Charging status can be monitored over the network
using WWB 6.
Ethernet Network
RF Signal
Ethernet Switch
ShowLink
Access Point
RF Antenna B RF Antenna A
Spectrum Manager
Receiver
Receiver
Receiver
Receiver
Rackmount
Battery Charger
26
Part 1: Introduction
AXT610
Axient Wireless
Showlink Acces Point
AXT900
B A
AXT600
B A
line
mic
lift
GND
in
word
clock
thru
Term 75Ω
line
mic
lift
GND
Class 1 PoE
AXT400
B A
line
mic
lift
GND
in
word
clock
thru
Term 75Ω
line
mic
lift
GND
Class 1 PoE
AXT400
B A
line
mic
lift
GND
in
word
clock
thru
Term 75Ω
line
mic
lift
GND
Class 1 PoE
AXT400
B A
line
mic
lift
GND
in
word
clock
thru
Term 75Ω
line
mic
lift
GND
Class 1 PoE
AXT400
AXT620
WWB6
AXT610