System information

Step 9: Matching inventory to live devices (including merging devices)
At the venue with the live devices set up and configured, load the show file and configure the devices. Open the show file
from the File > Open Show menu.
If the devices in the show file have never been matched to the actual live devices, WWB adds the offline devices to the
inventory. Drag each offline device onto its corresponding live device to merge them into a single device in the inventory.
Wireless Workbench will present
a merge dialog if the Frequency
parameters or Settings parameters
between the Live device (hardware)
and the offline device (WWB6) do
not match.
Tip: If you have a large number of devices to merge, turn OFF all live devices, load the show file, and then power on each live device one at a time to
easily identify which live device to merge with the offline device.
Note: An online device can only be merged
with an offline device and all devices must of
the same manufacturer, model, and band.
Tip: Refer to the Wireless Workbench 6 help
system chapter "Frequency and Settings
Parameters per Model" for more information.
To resolve differences between all Live and Offline devices, use the buttons next to the All Devices label.
To resolve the frequency and settings for individual devices, use the buttons next to the Individual Devices label.
Click on either the Frequency parameters or Settings parameters buttons to choose the parameters of the Live device or
of the offline device. When finished, click apply.
42
Part 2: System Setup and Configuration