System information

Assigning IP addresses to Networked Devices

Automatic IP addressing

1. Set the IP address mode to Automatic for all devices on the network.

Manual IP Addressing

1. Set the IP address mode to Manual for all devices on the network.

2. Connect the devices to an Ethernet switch.

3. Manually assign valid IP addresses to each device on the network.

Each device on the network must be assigned a unique IP address to ensure network communication. IP addresses can

be assigned automatically by a DHCP enabled server such as the Shure AXT620 Ethernet switch, or manually assigned

from a list of valid IP addresses.

Note: Selecting the reset option for a device will clear existing IP addresses and set the IP address mode to Automatic.

2. Connect the devices to a DHCP enabled server.

3. Upon connection, the server will automatically assign IP addresses to the devices.

Note: All IP addresses must be on the same subnet.

Tip: You can engage the Automatic IP mode on the AXT610 ShowLink Access Point by holding the reset button down until all LEDs blink while the

device is powered on. The AXT610 will then reboot into the Automatic IP mode.

Note: If a DHCP server is not connected, the IP addresses for each device will automatically fall back to an address of 169.254.x.x. If a DHCP

server is connected, IP addresses will automatically be assigned by the server. All Axient network devices will fall back to a private 169.254.x.x

addresswithinafewsecondsofpoweron;however,theUHF‐Rreceiverswilltakeupto60secondstofallbacktoa169.254.x.x.

Chapter 10 ‒ Networking