System information

72
Part 2: System Setup and Configuration
ShowLink signal quality for
AXT100-1
StartTx ShowLink Test
1: [AXT100-1]
2: [AXT100-2]
Menu acts on highlighted device.
ShowLink Test
‘SET’ to exit
|
ShowLink Test
‘SET’ to begin
|
Measuring Coverage Area with the ShowLink Test
The ShowLink Test in the AXT400 receiver finds the boundaries of the ShowLink coverage area. When the ShowLink
test is activated, a five-bar display indicating level of the signal quality appears on the screens of the transmitter and the
receiver. As the transmitter moves away from the access point, the number of bars will decrease. ShowLink control will be
maintained as long as 1 bar is displayed. If the transmitter is beyond the coverage range remote control will not be pos-
sible; however, the audio signal will not be affected or interrupted. To improve coverage, adjust the location of the access
point or place additional access points to extend coverage.
The ShowLink test can be activated from the receiver menu or from the transmitter menu:
1. From the receiver menu: Util > More >
ShowLink Test
2. Use the control wheel to highlight a transmitter to test.
3. Press Start and walk the transmitter around the cover-
age area. Monitor the number of bars displayed and
note the areas where 0 bars are displayed.
1. From the transmitter menu: Use the arrow buttons to
navigate to the ShowLink test menu screen.
4. Press Exit to end the ShowLink test.
3. Press the SET button to exit the ShowLink test.
2. Press the SET button to start the test and walk the
transmitter around the coverage area. Monitor the
number of bars displayed and note the areas where 0
bars are displayed.
Directional antennas such as the Shure AXT644 Directional
2.4 GHz Patch Antenna offer extended range and reduce
multi-path effects in crowded 2.4 GHz environments.
When using a 2.4 GHz directional antenna, be sure to elevate
and aim the antenna at the targeted coverage area.
To maximize the range of the AXT644 when used with
bodypack transmitters, it is important to match the angle of
the antenna with the transmitter position on the performer.
Angle the antenna as shown (noting the orientation of the
Shure logo).
Directional Antenna Options
set
Always check local regulations regarding the use of 2.4 GHz antennas.