System information

Perform an IR Sync to automatically tune and link the transmitter to a the receiver channel.
1. Select Tx from the receiver menu.
2. Align the transmitter and receiver IR ports. The red IR sync LED on the receiver IR port illuminates to indicate correct
alignment. Press Sync.
3. The receiver display indicates if the IR sync is successful. Check
transmitter alignment and select Retry if a failure occurs. The
receiver passes an audio signal if successful.
If the transmitter is ShowLink-ready, you will also briefly see a
Devices Linked message on the display.
4. To link a second transmitter to the same receiver channel:
• RF Mute the second transmitter before linking to prevent
interference
• Select Tx from the receiver menu
• Use the scroll wheel, highlight the 2: position under linked
devices
• Align the second transmitter to the IR port and select Sync
While speaking into the microphone or playing the instrument,
use one of the following methods to adjust the transmitter gain:
• From the receiver Tx menu with ShowLink remote control
• From WWB6 with ShowLink remote control
• From the transmitter gain menu
Adjusting Transmitter Gain
Note: If you IR sync over a linked transmitter, the transmitter will be unlinked from the receiver and removed from the ShowLink network.
Adjust the transmitter gain so that the loudest sound from a microphone or instrument connected to the transmitter causes
the LCD on the transmitter to read ‘INPUT OVERLOAD’ and the power LED on the transmitter to turn RED at the peaks,
indicatingthebestsignal‐to‐noiseratio.
Setting up an Audio Channel using IR Sync
81
Chapter 13 ‒ Audio Channels
navigate
navigate control monitor
power
clip
push
1
2
push
enter
exit
audioRF
audioRF
sync
AXT400
A 470-698 MHz
Dual Wireless Receiver
A B
OL
A B
OL
set
Input
Overload
set
IR Sync
Success!
Devices
Linked
Adjust
IR Presets
Unlink
Sync
Linked Devices:
1: [AXT200-1]
7:15
2: [AXT200-2]
Menu acts on highlighted device.
RF
Mute