User's Manual

6
Remove the battery
Unscrew the
locking ring
Batteries
Axient transmitters are powered by a Shure lithium-ion
rechargeable battery.
Caution: Turn off the transmitter before changing batteries.
Note: Refer to your battery charger manual for charging instructions.
Battery Runtime
Battery runtime varies according to the transmitter’s operating mode.
High power settings or operating in Frequency Diversity mode will
reduce battery runtime.
Remaining battery runtime is shown on the display in hours and minutes
(accurate to within 15 minutes).
The times shown in the table represent a battery with a minimum of 5
charge cycles, fully charged, at 100% health.
RF Power Mode Runtime
10 mW Single Carrier 9:45
Frequency Diversity 6:40
50 mW Single Carrier 8:00
Frequency Diversity 4:40
1
1
< U n l i n k e d >
F1: 525.725
F2: 585.625
}
|
9:25
4 5
6
6
2
1
7
8
3
Main Menu Screen
The main menu screen displays the following transmitter parameters:
① Link Status
• Linked : Displays Linked receiver
channel name
• Unlinked : Not Linked to a receiver
② Frequency 1
Tuned frequency 1 of the transmitter
③ Frequency 2
Tuned frequency 2 of the transmitter
(Frequency Diversity mode enabled)
④ Battery Charge Indicator
5-segment icon visually indicates battery life
⑤ Remaining Battery Life
Displays remaining battery life in hours and
minutes
⑥ Showlink Icon
Indicates remote control of transmitter
possible via ShowLink is possible
⑦ Audio Meter
Indicates the audio signal level
⑧ Control Lock Icon
Displayed when buttons are locked
Locking the Buttons
Lock the buttons of the transmitter to prevent accidental or unauthorized
parameter changes.
Press and hold the ▼ and ▲ buttons for 2 seconds to lock.
Repeat to unlock.
Power-on RF Mute
The transmitter can be powered-on in RF Mute mode to prevent
transmission of the audio signal.
Press and hold the ▼ button during power-on until the RF Muted
message is displayed.
Linking a Transmitter using IR Sync
The IR Sync function forms a Link and sets the frequency between the
transmitter and an AXT400 Receiver.
Using an AXT200 for Frequency Diversity
Operating an AXT200 in Frequency Diversity mode with an AXT400
receiver enables simultaneous transmission of audio on 2 independent
frequencies.
1. From the AXT400 Receiver menu: Radio > Options > Diversity
2. Use the control wheel to set the mode to On-Handheld.
3. Use the IR Sync function to Link the transmitter to the receiver.
navigate
navigate control monitor
power
clip
push
1
2
push
enter
exit
audioRF
audioRF
sync
AXT40 0
A 470-698 MHz
Dual Wireless Receiver
A B
OL
A B
OL
1. Align the IR Sync ports of the transmitter and the receiver. The red IR
Sync LED on the front panel of the receiver will illuminate to indicate
correct alignment.
2. Access the IR Sync function in the AXT400 Receiver menu: Tx > Sync
3. The receiver display indicates if the IR Sync is successful.
Check the transmitter alignment and select Retry if a failure occurs.
The transmitter device ID will be shown in the receiver Tx menu and
the receiver channel name and frequency will be shown on the
transmitter display, indicating a successful IR Sync.