BLX Wireless Microphone System Systeme de microphone sans fil BLX Sistema de micr6fonos inalambricos BLX Sistema de Microfone Sem Fio BLX ©2014 Shure Incorporated 27A16033 (Rev.
IMPORTANT SAFETY INSTRUCTIONS 1. 2. 3. 4. 5. 6. 7. 8. 9 10. 11. 12. 13. READ these instructions. KEEP these instructions. HEED all warnings. FOLLOW all instructions. DO NOT use this apparatus near water. CLEAN ONLY with dry cloth. DO NOT block any ventilation openings. Allow sufficient distances for adequate ventila· lion and install in accordance with the manufacturer's instructions.
& Caution For proper operation, set each transmitter to a different channel on the BLX88 receiver. Consult your BLX Channel guide to select compatible channel sets. &, Attention Pour un fonctionnement correct, regler chaque cote du recepteur double BLX88 sur un canal different. Consulter le guide des canaux BLX pour selectionner des jeux de canaux compatibles. & Cuidado Para opera~ao correta, ajuste cada lado do Receptor duplo BLX88 em urn canal diferente.
Quick Start Guide G) a) Connect receiver to power source. Brancher le recepteur a une source d'alimentation. Den Empfanger an die Stromversorgung anschlieBen. Conecte el receptor a Ia fuente de alimentaci6n. b) Connect receiver to mixer or amplifier. Hold power button to turn on. Brancher le recepteur a un melangeur ou un amplificateur. Appuyer sur le bouton d'alimentation pour allumer le recepteur. Den Empfanger an das Mischpuft oder den Verstarker anschlieBen.
a) l!~XI. ~j:l~ q~% Install batteries and turn on transmitter. lnstallate le pile ed accendete il trasmettitore. Installer les piles et allumer l'emetteur. lnstale as pilhas e ligue o transmissor. :ii:~ ~ne:Jt1T *~tim Die Batterien/Akkus einlegen und den Sender einschalten. BcTaBbTe 6aTapeHKH H BKJ1104HTe nepeAaT4HK. Pasang baterai dan hidupkan pemancar. lnstale las baterfas y encienda el transmisor. t.!71. ~~AI£. ~ilo i!i!•r;:•jm~.A.n. ;f"/(;: [.
If setting up additional systems, leave the first transmitter and receiver on. For each additional receiver, manually set the group to match the first receiver. Note: The receiver will automatically perform a channel scan to find an available frequency after the group has been selected. Set the transmitter frequency to match the receiver. Si l'on configure d'autres systemes, laisser les premiers emetteur et recepteur allumes.
English BLX Features Front Panel BLX4 SIIViUE reody BLX88 0 0 2 CD audio LED @ group and channel Buttons Scan: Push and release group button to scan for an open group and channel. Manual: Push and hold group button to select a group. Push channel button to select a channel in the current group. Indicates strength of incoming audio signal: green for normal and red for overload. ®ready LED Green light indicates system is ready for use and receiving transmitter signal.
English Back Panel BLX4 BLX88 4
English Transmitter LED Indicators LED Indicator Status Green Ready Rapidly Flashing Red Controls locked Solid Red Battery power low (less than 1 hour remaining*) Flashing Red and shuts off Batteries dead (change batteries to power on transmitter) *For alkaline batteries only. For rechargeable batteries, solid red means the batteries are dead.
English Multiple System Setup Up to 12 systems can operate simultaneously (band and RF environment dependent). Important: Set up each system one-at-a-time. Once a receiver and transmitter are tuned to the same group and channel, leave the transmitter powered on. Otherwise, scans from the other receivers will not detect that channel as occupied. For the BLX88, be sure to setup both transmitters before progressing to the next receiver.
English Tips to Improve Wireless System Performance If you encounter interference or dropouts, try the following suggestions: • Choose a different receiver channel • • • Reposition the receiver so there is nothing obstructing a line of sight to the transmitter (including the audience) Avoid placing transmitter and receiver where metal or other dense materials may be present Move the receiver to the top of the equipment rack • Remove nearby sources of wireless interference, such as cell phones, two-way r
English Batteries Expected life for AA batteries is up to 14 hours (total battery life varies depending upon battery type and manufacturer). 0 0 When the LED indicator turns red, it signifies "low battery" with approximately 60 minutes of remaining battery life. For alkaline batteries only. For rechargeable batteries, solid red means the batteries are dead. To remove batteries from the handheld transmitter, push them out through the opening in the microphone battery compartment.
English Troubleshooting Issue Indicator Status Solution No sound or faint sound Receiver ready LED on • Verify all sound system connections or adjust gain as needed (see Adjusting Gain) • Verify that the receiver is connected to mixer/ amplifier Receiver ready LED off • Turn on transmitter • Make sure the batteries are installed correctly • Perform transmitter setup (see Single System Setup) • Insert fresh batteries Receiver LED screen off • Make sure DC adapter is securely plugged into electrical
English BLX BLX2 Working Range Audio Input Level 91 m (300 ft) Line of Sight gain Note: Actual range depends on RF signal absorption, reflection and interference. OdB -20 dBV maximum -10dB -1 0 dBV maximum Gain Adjustment Range Audio Frequency Response 10 dB 50 to 15,000 Hz RF Transmitter Output Note: Dependent on microphone type Total Harmonic Distortion Ref. ±33 kHz deviation with 1 kHz tone 0.5%, typical 10 mW, typical varies by region Dimensions Dynamic Range 224 mm X 53 mm dia.
L..ll~llo;JII Important Product Information Certifications LICENSING INFORMATION This product meets the Essential Requirements of all relevant European directives and is eligible forCE marking. Licensing: A ministerial license to operate this equipment may be required in certain areas. Consult your national authority for possible requirements. Changes or modifications not expressly approved by Shure Incorporated could void your authority to operate the equipment.
United States, Canada, Latin America, Caribbean: Shure Incorporated 5800 West Touhy Avenue Niles, IL 60714-4608 USA www.shure.com Phone: +1-847-600-2000 Fax: +1-847-600-1212 (USA) Fax: +1-847-600-6446 Email: info@shure.com Europe, Middle East, Africa: Shure Europe GmbH Jakob-Dieffenbacher-Str. 12, 75031 Eppingen, Germany Phone: +49-7262-92490 Fax: +49-7262-9249114 Email: info@shure.
Description Energy-eHicient external switching mode ac/dc power supply, for use with Shure wireless microphone receivers, PSM transmitters, and audio mixer products world-wide. WARNING: Voltages in this equipment are hazardous to life. No user-serviceable parts inside. Refer all servicing to qualified service personnel. The safety certifications do not apply when the operating voltage is changed from the factory setting. IMPORTANT SAFETY INSTRUCTIONS 1. 2. 3. 4. READ these instructions.
SHU ® SHURE Incorporated http://www.shure.com United States, Canada, Latin America, Caribbean: 5800 W. Touhy Avenue, Niles, IL 60714-4608, U.S.A. Phone: 847-600-2000 U.S. Fax: 847-600-1212 lnt'l Fax: 847-600-6446 Europe, Middle East, Africa: Shure Europe GmbH, Phone: 49-7131-72140 Fax: 49-7131-721414 Asia, Pacific: Shure Asia Limited, Phone: 852-2893-4290 Fax: 852-2893-4055 SHURE Incorporated http://www.shure.com Etats-Unis, Canada, Amerique latine, Cara"ibes : 5800 W.
SHUiQ: LEGENDARY CVL PERFORMANCE The Shure CVL is an electret condenser lavalier microphone ideal lor use in speech and other applications requiring minimal visibility. Using the Microphone 1 Install the supplied windscreen on the microphone. 2. Attach the microphone to a shirt col lar or necktie using the supplied clip. For best results , the microphone should be 15-25 em (6-10 in.) away from the mouth. ©20 13 Shure lncorporatod 27A21262 (Rev.
Type Electret Condenser Frequency Response 50Hzto20,000Hz Polar Pattern Unidireetionai (Cardioid) Output Impedance @1kHz 6000 Audio Output Level -43.5dBVIPa Signal-To-Noise Ratlo l11 @1kHz 72dB Maximum SPL r•1 1000 a load,@ JOk.THO t39.0dB Equivalent Oulput Noise l'l typical, A-Weighted 22dB Power Requirements +5 V DC (nominal), 10 V maximum (DC bias) Type Condensateurir181ectret Reponse en fn!quence 50HziJ20.000Hz Courbe de direetivlte Unidirectionnel(cardioide) Impedance de sortie B t kHz 6000 Cable 1.
LEGENDAR Y PERFORMA NCE'"" Registe r Online: 3aper~crp~pyHrecb S'inscri re en ligne: ;f-/7.{/~-: Online- Registr ierung: 1£~)tHfr Registra zione on line: ~..ttt-mt: Registr ar Online: .2. 2. LQ I .5.5.. L... Ha se6-caHre: : rL..! o•· Registre -se Online: www.shure.com/register ©2008 Shure Incorporated 27C3092 (Rev.
Service Centers United States, Canada, Latin America, Carrlbbean Shure Incorporated Attn: Service Department 5800 W. Touhy Avenue Niles, IL 60714-4608 U.S.A. Europe, Middle East, and Africa Shure Europe GmbH Attn: Service Jakob-Dieffenbacher-Str. 12 7 4078 Eppingen, Germany Asia Shure Asia Limited 22/F, 625 King's Road North Point, Island East Hong Kong Attention: Service Department Phone: (852) 2893-4290 Fax: (852) 2893-4055 Email: info@shure.com.
LIMITED WARRANTY Shure Incorporated ("Shure") hereby warrants to the original consumer purchaser only that, except as otherwise specified below, this product will be free in normal use of any defects in materials and workmanship for a period of two (2) years from the consumer's original date of purchase directly from Shure or from a Shure-authorized reseller.
® LIMITED WARRANTY © 2012, Shure Incorporated ~a 27E3175 (Rev. 1) ti~ Printed in China IL16.GSI31.00501.
