SHUR.E® LEGENDARY PERFORMANCE™ WIRELESS SYSTEM BLX4R USER GUIDE Le Guide de l'Utilisateur Guia del Usuario Manual do Usuario © 2015 Shure Incorporated 27A29733 (Rev.
IMPORTANT SAFETY INSTRUCTIONS 1. 2. 3. 4. 5. 6. READ these Instructions. KEEP these instructions. HEED all warnings. FOLLOW all instructions. 00 NOT use this apparatus near water CLEAN ONLY with dry cloth. 7. DO NOT block any ventilation openings. Allow sufficient distances for adequate ventilation and install in accordance with the manufacturer's instructions.
Quick Start Guide Connect receiver to power source. 0 Brancher le recepteur a) a une source d'alimentation. Conecte el receptor a la fuente de alimentaci6n. Conecte o receptor a fonte de alimentagao. Connect receiver to mixer or amplifier. Press the power button to turn on the receiver. b) a Brancher le recepteur un melangeur ou un amplificateur. Appuyer sur le bouton d'alimentation pour allumer le recepteur. Conecte el receptor a la mezcladora o amplificador.
@ a) Install batteries and turn on transmitter. Installer les piles et allumer l'emetteur. lnstale las baterfas y encienda el transmisor. lnstale as pilhas e ligue o transmissor. 0 0 b) On the transmitter, set the group and channel to match the receiver. The RF bars and battery LED on the receiver should illuminate. Sur l'emetteur, regler le groupe et le canal afin qu'ils correspondent ceux du recepteur. Les barres RF et la LED des piles du recepteur doivent s'allumer.
If setting up additional systems, leave the first transmitter and receiver on. For each additional receiver, manually set the group to match the first receiver. Note: The receiver will automatically perform a channel scan to find an available frequency after the group has been selected. Set the transmitter frequency to match the receiver. Si l'on configure d'autres systemes, laisser les premiers emetteur et recepteur allumes.
BLX4R BLX4R Receiver Front Panel Rear Panel SHU~BLX4R ® Antenna Jack B G) Transmitter Battery LED - Green = Runtime greater than 1 hour - Red = Runtime less than 1 hour ® BNC connector for antenna B. (z) DC Power Jack LCD Display Displays receiver and transmitter settings. For DC external power supply (12 to 15 V DC). @ group Button - Scan: push and release group button to scan for an open group and channel - Manual: push and hold group button to select a group.
Transmitters BLX1 G) LED Indicator Displays power and battery status (see table). @ power Switch Toggles power on or off. 0--- SNUiQS @4-Pin Microphone Input Jack (TA4 connector) © Antenna ® group Button Changes group setting. @ LED Display Displays group and channel setting. 0 channel Button Changes channel setting. @ Battery Compartment ® Audio Gain Adjustment Rotate to increase or decrease transmitter gain. BLX2 G) LED Indicator Displays power and battery status (see table).
Single System Set Up Setting Transmitter Group and Channel Transmitter group and channel must be manually set to match the receiver. Group (letter) Before you begin, turn off all transmitters and turn on any equipment (other microphones or personal monitoring systems) that could cause interference during the performance. 1. Press and release the group button on the receiver. 1. Press and release the group button on the transmitter to activate the display.
Tips to Improve Wireless System Performance If you encounter interference or dropouts, try the following suggestions: • Choose a different receiver channel • Reposition the receiver so there is nothing obstructing a line of sight to the transmitter (including the audience) • Avoid placing transmitter and receiver where metal or other dense materials may be present • Move the receiver to the top of the equipment rack • Remove nearby sources of wireless interference, such as cell phones, two-way radios, compu
Batteries Expected life for AA batteries is up to 14 hours (total battery life varies depending upon battery type and manufacturer) . When the LED indicator turns red , it signifies "low battery" with approximately 60 minutes of remaining battery life. For alkaline batteries only. For rechargeable batteries, solid red means the batteries are dead. To remove batteries from the handheld transmitter, push them out through the opening in the microphone battery compartment.
Troubleshooting Issue Indicator Status Solution No sound or faint sound Receiver RF bars and battery LED illuminated • Verify all sound system connections or adjust gain as needed (see Adjusting Gain) • Verify that the receiver is connected to mixer/amplifier Receiver RF bars and battery LED off • • • • Receiver screen off • Make sure AC adapter is securely plugged into electrical outlet. • Make sure receiver is powered on .
Specifications System ------------------------------- BLX2 Audio Input Level Working Range 91 m (300 ft) Line of Sight Note: Actual range depends on RF signal absorption, reflection and interference. gain 0dB -20 dBV maximum 1---------+---------10dB -10 dBV maximum Audio Frequency Response 50 to 15,000 Hz Note : Dependent on microphone type Gain Adjustment Range Total Harmonic Distortion RF Transmitter Output Ref. ±33 kHz deviation with 1 kHz tone 10 mW, typical varies by region 10dB 0.
Certifications BLX1,BLX2,BLX4R LICENSING INFORMATION Meets requirements of the following standards: EN 300 422 Parts 1 and 2, EN 301 489 Parts 1 and 9, EN60065. Licensing: A ministerial license to operate this equipment may be required in certain areas. Consult your national authority for possible requirements. Changes or modifications not expressly approved by Shure Incorporated could void your authority to operate the equipment.
LEG EN DARY PERFORMANCE~ United States, Canada, Latin America, Caribbean: Shure Incorporated 5800 WestTouhy Avenue Niles, IL 60714-4608 USA Phone:+ 1 847-600-2000 Fax: +1 847-600-1212 (USA) Fax:+ 1 847-600-6446 Email: info@shure.com www.shure.com Europe, Middle East, Africa: Shure Europe GmbH Jakob-Dieffenbacher-St,. 12, 75031 Eppingen, Germany Phone: +49-7262-92490 Fax: +49-7262-9249114 Email: info@shure.de www.shure.
+10 WL 183 FREQUENCY RESPONSE .... '\, -10 20 50 100 200 500 1,000 2,000 5,000 10,000 20,000 Hz +10 ~ Lavaller Electret Condenser Micro hones Models WL 183, WL 184 and WL 185 are lavalier electret condenser microphones for use with a wireless bodypack transmitter. Each microphone has a 1.2 meter (4 ft.) cable terminated with a miniature 4-pin connector (TA4F). The furnished tie clip can be rotated in 90° intervals for placement flexibility.
MODEL WL93T WL93-6 WL193-6T S eclfications Type: Condenser (electret bias) Frequency Response: Model WL93 Microphones are omnidirectional, subminiature , lavalier electret condenser microphones designed for use in TV broadcasting, theater, and sound reinforcement applications where a visually unobtrusive microphone is desirable. All WL93 models are supplied with a mounting block with attached tie bar, a sew-on mounting bracket, and an acoustic windscreen to minimize wind noise in outdoor applications.
® SI LIMITED WARRANTY 111111111111111111 IIII IIIII IIIII IIIII IIII IIII ~~ © 2018, Shure Incorporated 27F3175 (Rev. 4) tt, Printed in China. I 1.16.GSl31.00501.
tCl SHURE~ Service Centers United States, Canada, Latin America, Carribbean Shure Incorporated Attn: Service Department 945 Chaddick Dr. Wheeling, IL 60090-6449 Europe, Middle East, and Africa Shure Europe GmbH Attn: Service Jakob-Dieffenbacher-Str. 12 75031 Eppingen, Germany Asia Shure Asia Limited 22/F, 625 King's Road North Point, Island East Hong Kong Attention: Service Department Phone: (852) 2893-4290 Fax: (852) 2893-4055 Email: info@shure.com.hk i.i l....::u ·<1 ..
LIMITED WARRANTY Shure Incorporated ("Shure") hereby warrants to the original consumer purchaser only that, except as otherwise specified below, this product will be free in normal use of any defects in materials and workmanship for a period of two (2) years from the consumer's original date of purchase directly from Shure or from a Shure-authorized reseller.
FOR ORIGINAL PURCHASES IN AUSTRALIA ONLY LIMITED WARRANTY AGAINST DEFECTS Shure Incorporated ("Shure") hereby warrants to the original consumer purchaser in Australia only that, except as otherwise specified below, this product will be free in normal use of any defects in materials and workmanship for a period of two (2) years from the consumer's original date of purchase directly from Shure or from a Shure-authorized reseller.
