User's Guide
Table Of Contents
- BLXWireless System
- IMPORTANT SAFETY INSTRUCTIONS
- System Components
- Quick Start Guide
- Features
- Single System Set Up
- Setting Transmitter Group and Channel
- Multiple System Setup
- Manually Setting Receiver Group and Channel
- Locking and Unlocking Controls
- Tips to Improve Wireless System Performance
- Getting Good Sound
- Adjusting Gain
- Batteries
- Wearing the Bodypack Transmitter
- Power Off
- Removing and Installing Identification Caps
- Troubleshooting
- Specifications
- System
- Working Range
- Audio Frequency Response
- Total Harmonic Distortion
- Dynamic Range
- Operating Temperature
- Polarity
- BLX1
- Audio Input Level
- Gain Adjustment Range
- Input Impedance
- RF Transmitter Output
- Dimensions
- Weight
- Housing
- Power Requirements
- Battery Life
- Audio Input Level0dB-20 dBV maximum-10dB-10 dBV maximumGain Adjustment Range10 dB RF Transmitter Output10 mW, typical varies by region Dimensions8.82 in. X 2.09 in. (224 mm X 53 mm) L x Dia. Weight7.7 oz. (218 g) without batteries HousingMolded ABS Power Requirements2 LR6 AA batteries, 1.5 V, alkaline Battery Lifeup to 14 hours (alkaline)
- Audio Input Level
- Gain Adjustment Range
- RF Transmitter Output
- Dimensions
- Weight
- Housing
- Power Requirements
- Battery Life
- BLX4 & BLX88
- Output Impedance
- Audio Output Level
- RF Sensitivity
- Image Rejection
- Dimensions
- Weight
- Housing
- Power Requirements
- Certifications
- Important Product Information
- Frequency Range and Transmitter Output Level
Shure Incorporated
13/25
For alkaline batteries only. For rechargeable batteries, solid red means the batteries are dead.
To remove batteries from the handheld transmitter, push them out through the opening in the microphone battery
compartment.
WARNING: Battery packs shall not be exposed to excessive heat such as sunshine, fire, or the like.
Wearing the Bodypack Transmitter
Clip the transmitter to a belt or slide a guitar strap through the transmitter clip as shown.
For best results, the belt should be pressed against the base of the clip.
Power Off
Hold down the power button to power off the BLX2 or BLX4/88. To power off the BLX1, slide the power toggle switch
to OFF.