User's Manual
Table Of Contents
- Table of Contents
- DH5 DuraPlex™ Omnidirectional Headset
- General Description
- Care and Maintenance
- Care and Maintenance
- Adjusting the Headband and Microphone
- Presence Cap
- Attaching the Windscreen
- Using the Collar Clip
- Accessories
- Accessories
- Threaded Mount Instructions
- Wiring and Termination
- Wiring and Termination
- Specifications
- Certifications
Shure Incorporated
12/14
•
•
Note: Make sure to solder the shield to ground collar.
Assembled View
Specifications
Note:
All specification values are based on using a typical bodypack with 5 V bias input or the RPM400MTQG preamplifier.
When using the RPM400LEMO amplifier, refer to the RPM400LEMO specifications.
All specifications measured with a 48 Vdc phantom power supply. The microphone operates at lower voltages, but with
slightly decreased headroom and sensitivity.
Microphone Capsule
MEMS
Polar Pattern
Omnidirectional
Frequency Response
20 Hz to 20 kHz
Sensitivity
-42.5dBV at 1 kHz
Self-Noise, A-Weighted, Equivalent Acoustical
31dBSPLA
Signal-To-Noise Ratio
63.0dB
Maximum SPL
132.0dBSPL,1 kHz at 1% THD, typical
Dynamic Range
101.0dB typical
Microphone Current Draw
220µA,maximum
[1]
[2]
[3]