User guide

10
Indicator: Needle or Strobe
Choosing Live or Mute Audio Output
Detune
Needle
A single LED will illuminate on
the tuning bar to indicate sharp
or flat. The green center LED
will illuminate when the note is
in tune.
Strobe
A sequence of three LEDs will travel
across the tuning bar in the direction of
sharp or flat. The LEDs will remain sta-
tionary when the note is in tune.
Reference Pitch
The tuner indicator can be set to display a needle style or strobe style.
The following modes are available to set the audio output to Live or Mute
when the footswitch is pressed in tuner mode.
Note: Text for the output settings are displayed in a scroll from left to right.
Mode Footswitch Function
Live Receiver Display (audio Live) ↔ Tuner Display (audio Live)
Mute Receiver Display (audio Live) ↔ Tuner Display (audio Mute)
Both Tuner Display (audio Mute) ↔ Tuner Display (audio Live)*
*Note: In Both mode, the pedal powers up in Receiver Display. Press the footswitch
to enter tuner mode.
The tuner can be set to display standard tuning for instruments that have
been detuned up sharp or flat in the following increments:
• Up to 5 steps sharp (#1-#2 -#3-#4-#5)
• Up to 6 steps flat (b6-b5-b4-b3-b2-b1)
The notation for standard tuning is b0
Adds sharp or flat symbols to the display of non-natural notes.
The reference pitch can be offset from standard A440 in a range of 432 Hz
to 447 Hz in 1 Hz increments.
When adjusting the pitch, the last 2 digits of the value will be displayed.
For example, "32" would appear on the display when the pitch has been
set to 432 Hz.
A440 447 Hz432 Hz
Display Brightness
The receiver has a built-in light sensor to automatically adjust the display
brightness.
To manually adjust the brightness choose one of the following settings:
Tuner Options
• Indicator: Needle or Strobe
• Output: Live, Mute, or Both
• Display Brightness
• Detune
• Sharps and Flats
• Reference Pitch
Selecting and Editing Tuner Menu Settings
Use the following buttons to select and edit the tuner
menu settings:
• Use the mode button access the menu and to
scroll between menu settings
• Use the Use ▲ ▼ buttons to change a menu
parameter
• Use the footswitch to enter and save parameter
changes
Tuner Menu
Enter tuner mode by pressing the footswitch.
In tuner mode, the controls will only affect tuner functions, RF and audio settings are not affected.
Note: The audio signal does not pass through the tuner, eliminating the need for bypass switches commonly found on wired tuners.
Note: Indicator and Output settings are displayed in a scroll from left to right.
rf channel
group
auto
link
mode
Sharps and Flats
A dot appears on the display as a reminder that the reference pitch has been offset.
*A = automatic
*1 = low
*2 = medium
*3 = high
Sharps and Flats
Flats only
Sharps only
b0
= Standard Tuning
Example of note displayed in Detune
mode
* dot appears on the display as a reminder that the pedal is detuned.