User's Manual

11
Indicator: Needle or Strobe
Output: Live or Mute
Detune
Needle
A single LED will illuminate on
the tuning bar to indicate sharp
or flat. The green center LED will
illuminate when the note is in tune.
Strobe
A sequence of three LEDs will
travel across the tuning bar in the
direction of sharp or flat. The LEDs
will remain stationary when the
note is in tune.
Frequency Offset
b0
b1
b2
The tuner indicator can be set to display a needle style or strobe style.
The audio output can be set to Live or Mute in tuning mode:
• Live: Audio is passed to the amplifier or mixer
• Mute: Audio is muted at the pedal output
The Detune feature can detect instruments that have been detuned up to
2 semitones (half steps).
The display will indicate the detuning as follows:
Adds sharp or flat symbols to the display of non-natural notes.
Frequency Offset adjusts the reference frequency from A440. The range
of adjustment is 432 Hz to 447 Hz in 1 Hz increments.
When adjusting the frequency, the last 2 digits of the value will be show.
For example, "32" would appear on the display when the frequency has
been set to 432 Hz.
Note: Two dots appear in the display as a reminder that the reference frequency is offset.
A440 447 Hz432 Hz
Display Brightness
The receiver has a built-in light sensor to automatically adjust the display
brightness.
To manually adjust the brightness choose one of the following settings:
*
1
*
A
*
2
*
3
L....i....v....e
M....u....t....e
N..e..e..d..l..e
S..t..r..o..b..e
#b
b
#
*A = automatic *1 = low *2 = medium *3 = high
Tuner Options
• Indicator: Needle or Strobe
• Output: Live or Mute
• Display Brightness
• Detune
• Sharps and Flats
• Frequency Offset
Selecting and Editing Tuner Menu Settings
Use the following buttons to select and edit the tuner
menu settings:
• Use the mode button access the menu and to
scroll between menu settings
• Use the Use ▲ ▼ buttons to change a menu
parameter
• Use the footswitch to enter and save parameter
changes
Tuner Menu
Enter tuner mode by pressing the footswitch. In tuner mode, the controls will only affect tuner functions. Receiver RF setting will not be affected.
Note: Indicator and Output settings are displayed in a scroll from left to right.
Note: Indicator and Output settings are displayed in a scroll from left to right.
rf channel
group
auto
link
mode
M...e...n...u
Sharps and Flats
Sharps and Flats Flats only Sharps only
b0
= Standard Tuning
b1 = 1 Semitone b2 = 2 Semitones
Note: Two dots appear in the display as a reminder that the pedal is detuned.
DRAFT
3.4.13