User guide

English
10
RECEIVER CONNECTIONS
1. Attach the supplied quarter-wave antenna(s) to the antenna connector(s) on the
receiver back panel. For best performance, the LX4 receiver antennas should be
oriented with the tips pointing away from each other at a 45° angle from vertical.
The LX3 receiver antenna should be vertical.
2. Connect the receiver output to the mixer or amplifier input, using a standard audio
cable with a female 3-pin XLR connector or 1/4-inch phone plug.
3. Connect the ac adapter to the POWER jack on the rear panel of the receiver.
4. Plug the ac adapter into an appropriate ac power source.
RECEIVER CONNECTIONS
FIGURE 8
NOTE: If the receiver is rack-mounted, the antenna(s) must extend above the rack
cabinet or be remotely located.
Improved LX4 diversity performance may be obtained by installing one or both
antenna(s) at a remote location and separating them by 1.5 meters (60 inches) or
more. Shure WA380 telescoping or WA490 cable-type 1/2-wave antennas are
recommended for remote location, and they should be connected to the receiver via
WA421 Extension Cable Kit(s) or other suitable low-loss cable.
WIRELES
S
RECEIVER
RF
AUDIO
SQUELCH
LEVEL POWER
ANT
OUTPUT
HI Z POWER
12.5 – 18.9 VDC
45° 45°
LX4
LX3
AUDIO MIXER
LX4
LX3
AUDIO MIXER