MX100 Series Lavalier Microphones Online user guide for Shure Microflex MX100 Series lavalier microphones.
Shure Incorporated Table of Contents MX100 SeriesLavalier Microphones General Description Interchangeable Cartridges Windscreen Preamp Gain 5 RFI Filtering 5 General Rules for Lavalier Microphone Use 5 Tie Clip 5 Specifications 6 Certifications 7 3 3 3 4 Foam Screen 5 Snap-Fit Windscreen 5 2/8
Shure Incorporated MX100 Series Lavalier Microphones General Description ® Shure Microflex MX100 Series microphones are wired lavalier electret condenser microphones designed for speech and vocal pickup, general purpose sound reinforcement, recording, and remote monitoring applications. They can be clipped to neckties, lapels, and other articles of clothing. Interchangeable cartridges make it possible to easily reconfigure microphone coverage as the need arises.
Shure Incorporated 4/8
Shure Incorporated Windscreen Foam Screen Slip the windscreen over the top of microphone so it covers side slots. The foam windscreen provides 5 to 10 dB of "pop" pro tection. Snap-Fit Windscreen • Snap into the groove below the cartridge. • To remove, spread the gap with a screwdriver or thumbnail. • Provides 30 dB of "pop" protection. Preamp Gain If necessary, the preamplifier gain can be reduced by 12 dB. Contact an authorized Shure service center for information.
Shure Incorporated Specifications Type Electret Condenser Frequency Response 50–17000 Hz Polar Pattern MX183 Omnidirectional MX185 Cardioid MX184 Supercardioid Output Impedance 180 Ω Output Configuration Active Balanced Sensitivity @ 1 kHz, open circuit voltage Cardioid –35 dBV/Pa(18 mV) Supercardioid –34 dBV/Pa(21 mV) Omnidirectional –28 dBV/Pa(42 mV) 1 Pa=94 dB SPL Maximum SPL 1 kHz at 1% THD, 1 kΩ load Cardioid 124 dB Supercardioid 123 dB Omnidirectional 117 dB Self Noise A-weig
Shure Incorporated Supercardioid 68 dB Omnidirectional 74 dB Dynamic Range 1 kΩ load, @ 1 kHz 96 dB Common Mode Rejection 10 Hz to 100 kHz 45 dB, minimum Clipping Level at 1% THD –6 dBV (0.5 V) Polarity Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector Environmental Conditions Operating Temperature –18–57°C (0–135°F) Storage Temperature –29–74°C (–20–165°F) Relative Humidity 0–95% Power Requirements 11–52 V DC, 2.
Shure Incorporated 75031 Eppingen, Germany Phone: +49-7262-92 49 0 Fax: +49-7262-92 49 11 4 Email: info@shure.
