User's Manual
Table Of Contents
- Table of Contents
- MX392 MX393Boundary Microphones
- General Description
- Interchangeable Cartridges
- Interchangeable Cartridges
- Permanent Installation
- Configuration
- Wiring Diagram
- Mute Button Configuration
- Connecting to an Automatic Mixer
- Logic Wiring
- Changing SWITCH OUT to Always Momentary
- Painting
- Specifications
- Furnished Accessories
- Certifications
Shure Incorporated
7/16
1.
2.
3.
1.
2.
3.
Pressure Sensitive Adhesive
Thoroughly clean the application area with the included alcohol wipe. Removing the dust will allow the microphone to
adhere well.
Remove the adhesive backing and gently set the microphone into position.
Once the microphone is in position, firmly apply pressure to the microphone.
Note: The pressure sensitive adhesive will be extremely difficult to move once pressure has been applied.
Bottom view of MX392BE/C with adhesive pads
Re-Routing Cable for Bottom Exit (If your MX392 is not BE configured)
Remove the grille.
Disconnect wires from screw terminals.
Grasp rubber boot within 1/2" of housing, using gas pliers. Rotate boot and cable ccw to remove connector from thread
ed "L" bracket.