User Manual

Shure Incorporated
13/102
Back Panel
AC Power
IEC connector 100 - 240 V AC.
Power Switch
Powers the unit on or off.
Output Block Connectors (1-8)
Three-pin, low-voltage differential connector provides a line-, aux- or mic-level analog output for each channel.
Chassis Ground (1-8)
Use to directly ground the cable shield to the chassis.
Input Block Connectors (A,B)
Three-pin, low-voltage differential input connector adds line- or aux-level analog signals to the digital network.
Note: This input is meant for balanced connection. If an unbalanced source is used, such as an IPOD or MP3 player, only use pins 1 (signal) and 3 (ground) of
the block connector. See Specifications sections for wiring diagrams.
Reset Button
Press and hold the button for five seconds to reboot the device with factory default settings.
Ethernet Status LED (Green)
Off = no network link
On = network link established
Flashing = network link active
Ethernet Link Speed LED (Amber)
Off = 10/100 Mbps
On = 1 Gbps (required for digital audio routing)
Network Interface
Four-port gigabit switch for connecting components together for a single MXW Group, or for connecting multiple devices to
a larger digital audio network. The following is a description of each port:
Port Description
Port 1 (PoE)
Provides Power over Ethernet (PoE) for the Shure access point and functions as a standard gigabit
port.