User Manual
Shure Incorporated
60/102
1.
2.
3.
Place the Access Point in the center of the installation for best coverage
Using Multiple 2- or 4-Channel Access Points
The MXW access point uses two sets of antennas to cover the operating spectrum. Each antenna set covers half of the timesī
lots used for MXW channels. Eight-channel units use both antenna sets simultaneously; two- and four-channel units use one
set at a time, operating on half of the available timeslots. The full spectrum can be covered they are configured to alternating
antenna sets.
When an installation uses multiple two- or four-channel access points (APT2 or APT4), configure the access point settings to
maximize channel count. This is particularly important for APTs that are mounted in the same or neighboring rooms.
Alternate Antenna Modes to use the Full Spectrum
Requirements
The MXW system must be operating on a minimum firmware version of 2.0.0.
Set Up
Open the MXW control software using the Shure Web Device Discovery application.
Go to the Utility page.
Open the Device Properties window for the two- or four-channel access point (MXWAPT2 or MXWAPT4).