User Manual

Shure Incorporated

67/102

Port TCP/UDP Protocol Description

Factory De

fault

843* tcp Flash Required for web application Open

2202 tcp ASCII Required for 3rd party control strings Open

5353 udp mDNS Required for device discovery Open

5568 udp SDT Required for inter-device communication Open

8023 tcp Telnet Debug console interface Password

8180* tcp Flash Required for web application Open

8181* tcp Flash Required for web application Open

8427 udp Multcast SLP Required for inter-device communication Open

64000 tcp Telnet Required for Shure firmware update Open

Dante Audio & Controller

Port TCP/UDP Protocol Description

162 udp SNMP Used by Dante

[319-320]* udp PTP Dante clocking

4321,

14336-14600

udp Dante Dante audio

[4440, 4444,

4455]*

udp Dante Dante audio routing

5353 udp mDNS Used by Dante

[8700-8706,

8800]*

udp Dante Dante Control and Monitoring

8751 udp Dante Dante Controller

16000-65536 udp Dante Used by Dante

*These ports must be open on the PC or control system to access the device through a firewall.

These protocols require multicast. Ensure multicast has been correctly configured for your network.

Packet Bridge

Packet bridge enables an external controller to obtain IP information from the control interface of a Shure device. To access the

packet bridge, an external controller must send a query packet over unicast UDP* to port 2203 on the Dante interface of the

Shure device.

Send a UDP packet with a minimum 1-byte payload .

Note: The maximum accepted payload 140 bytes. Any content is allowed.

†