User's Manual

Shure Incorporated
17/97
◦
◦
◦
◦
◦
◦
◦
•
•
Color Indicator
Flashing Red Link procedure has been locked from the control software.
Blue Charger is in High Efficiency Mode.
④ Microphone Link Button
Press and hold for 6 seconds to link all microphones in the charger to channels of the associated Access Point Transceiver.
Within the first minute of powering up the charger, press and release the Link button 3 times in succession to place the
charger in High Efficiency Mode. You must power cycle the charger to return to standard charging mode.
⑤ Battery Status LEDs
Monitors the charge status of the connected microphone in increments of <10, 10, 25, 50, 75, 100% (see Batteries for more
detail).Additionally,thefiveLEDsflashforseveralsecondswhenthemicrophonehasbeensuccessfullylinkedtothechan
nel.
⑥ Locking DC Power Supply
Secures the PS60 power supply to the input jack of the station.
⑦ Power Switch
Powers the unit on or off.
⑧ Ethernet Port
Connects to the MXW System network through an MXW Audio Network Interface or a switch using an Ethernet cable.
⑨ Ethernet Status LED (Green)
Off = no network link.
On = network link established.
Flashing = network link active.
⑩ Ethernet Link Speed LED (Amber)
Off = 10 Mbps
On = 100 Mbps
Connecting Microphones
Place a microphone in the charger by connecting it to one of the channel slots. The channels in the top row have two USB
ports to accommodate different types of microphones. Do not attempt to connect to both USB ports at the same time.
Note: 2-channel chargers do not support gooseneck microphones.
Handheld, boundary and bodypack: use the main vertical slots in the recessed bays.
Gooseneck base: uses the top row's horizontal connectors.