User's Manual
Table Of Contents
- Table of Contents
- MXW Microflex® Wireless
- IMPORTANT SAFETY INSTRUCTIONS
- Overview
- Overview
- Hardware Description
- Installation
- System Set Up
- System Set Up
- Large Installations
- Wireless Management
- Networking
- Networking
- Software
- Troubleshooting
- Accessories and Model Variations
- Microflex Wireless Specifications
- Microflex Wireless Specifications
- System
- Transmitters
- Gain Adjustment Range
- Maximum Input Level
- Headphone Output
- Maximum Headphone Output Power
- Antenna Type
- Antenna Gain
- Charge Connector
- Housing
- Recommended Storage Temperature Range
- MXW1 Hybrid Bodypack Transmitter
- Microphone Connector
- Input Impedance
- Internal Microphone
- Battery Life
- Dimensions
- Weight
- MXW2 Handheld Transmitter
- Microphone Capsule
- Configuration
- Input Impedance
- Battery Life
- Dimensions
- Weight
- MXW6 Boundary Transmitter
- Microphone Capsule
- Battery Life
- Dimensions
- Weight
- MXW8 Gooseneck-Base Transmitter
- Microphone Connector
- Configuration
- Input Impedance
- Gooseneck Options
- Battery Life
- Dimensions
- Weight
- Access Point Transceiver (APT)
- Networked Charging Station (NCS)
- Audio Network Interface (ANI)
- Audio Network Interface (ANI)
- Audio Frequency Response
- Dynamic Range
- Output Noise
- THD+N
- Polarity
- Dimensions
- Weight
- Housing
- Power Requirements
- Operating Temperature Range
- Storage Temperature Range
- Analog Connections
- Outputs
- Input(s)
- Headphone Output
- Digital Signal Processing
- AD/DA Converter
- Latency
- Networking
- Network Interface
- Uplink Port (Port 4)
- Power over Ethernet (PoE)
- Cable Requirements
- Network Addressing Capability
- Transmitter Output Power
- Wiring Diagram
- Safety Information
- Important Product Information
- Certifications
Shure Incorporated
96/97
•
•
•
•
1.
2.
3.
4.
1.
2.
1.
2.
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
經審驗合格之射頻電信終端設備,非經許可,公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及
功能。
射頻電信終端設備之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,應立即停用,並改善至無干擾時方得
繼續使用。所謂合法通信,係指依電信法規定作業之無線電信。
輸入、製造射頻電信終端設備之公司、商號或其使用者違反本辦法規定,擅自使用或變更無線電頻率、電功率者,除依電
信法規定處罰外,國家通訊傳播委員會並得撤銷其審驗合格證明。
減少電磁波影響,請妥適使用
Bodypack Microphone Transmitters
Thesetransmittershavebeentestedandfoundtocomplywithinternationalradiationexposurelimitssetforthforanuncon
trolled environment. This equipment is in direct contact with the body of the user under normal operating conditions. These
transmitters must not be co-located or operating in conjunction with any other antenna or transmitter.
Handheld Microphone Transmitters
Tabletop Boundary Microphone Transmitters
Tabletop Gooseneck Microphone Transmitters
Wireless Access Point Transmitters
These mobile transmitters are intended for use at distances greater than 20 centimeters from the human body. These mobile
transmitters are exempt from the testing requirements of international radiation exposure standards due to their proximity to the
body of the user in their intended use case and their low power output. These mobile transmitters shall be placed or installed at
least 20 cm from any person and must not be co-located or operating in conjunction with any other antenna or transmitter.
Certifications
This device complies with FCC Part 15.
Thisdevicecontainslicenceexempttransmitter(s)/receiver(s)thatcomplywithInnovation,ScienceandEconomicDevelop
mentCanada’slicenceexemptRSS(s).Operationissubjecttothefollowingtwoconditions:
This device may not cause interference.
This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteurexemptdelicencecontenudansleprésentappareilestconformeauxCNRd’Innovation,Scienceset
DéveloppementéconomiqueCanadaapplicablesauxappareilsradioexemptsdelicence.L’exploitationestautoriséeauxdeux
conditions suivantes :
L’appareilnedoitpasproduiredebrouillage;
L’appareildoitacceptertoutbrouillageradioélectriquesubi,mêmesilebrouillageestsusceptibled’encompromettrele
fonctionnement.
Japanese Radio Law and Japanese Telecommunications Business Law Compliance. This device is granted pursuant to the
Japanese Radio Law (電波法) and the Japanese Telecommunications Business Law (電気通信事業法). This device should not
be modified (otherwise the granted designation number will become invalid).
Conforms to electrical safety requirements based on IEC 60065.
This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking.